iHome iSP5 Quick Start Manual
iHome iSP5 Quick Start Manual

iHome iSP5 Quick Start Manual

Smartplug

Advertisement

PLUG OVERVIEW:

Power Indicator
Button
• Press once to manually control the switch (Turning plug "On" or "Off")
• Press and hold for 10 seconds to reset the software
(LED will flash red and green and SmartPlug will reset upon release.
Use app to reconfigure network settings)
Wi-Fi Status Indicator
Flashing Green: SmartPlug is searching for a Wi-Fi network
Solid Green: SmartPlug is connected to a Wi-Fi network
Flashing Red: SmartPlug is disconnected from a Wi-Fi network
Power On/Off Status Indicator
• Lights up when SmartPlug is "On" and electricity is flowing through
• Power indicator will blink once when firmware is successfully installed

Electrical Ratings

120V Volts AC, 60Hz
15A
1800W

Safety Warnings

• Plug directly into electric outlet (not into extension cord)
• For indoor use only
• Remove Smartplug from outlet before cleaning
• DO NOT clean with liquid
• DO NOT remove ground pin (middle pin)
• DO NOT use in wet or damp areas
• Keep children away from SmartPlug and outlet
• DO NOT exceed the recommended electrical ratings
• DO NOT use in precision timing applications where inaccurate timing could
be dangerous (sunlamps, saunas, etc.)
• DO NOT use with devices that should not be operated unattended

Recommendations

• Test device locally for safe operation before attempting to control it remotely
• DO NOT use with an oulet controlled by a wall switch as the switch may be off
Button
Wi-Fi Status Indicator

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the iSP5 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for iHome iSP5

  • Page 1 PLUG OVERVIEW: Button Power Indicator Wi-Fi Status Indicator Button • Press once to manually control the switch (Turning plug “On” or “Off”) • Press and hold for 10 seconds to reset the software (LED will flash red and green and SmartPlug will reset upon release. Use app to reconfigure network settings) Wi-Fi Status Indicator Flashing Green: SmartPlug is searching for a Wi-Fi network...
  • Page 2 1. Make sure your mobile device is connected to your preferred Wi-Fi network. 2. Download and open the free iHome Control app from the App Store or Google Play. (Apple: iOS 8.1 or later; Android: Jelly Bean 4.2 or later) 3.

Table of Contents