Table of Contents
Advertisement
D. Hooking Machine to Sink:
1. Tighten garden hose swivel nut (fig-
ure 8) to the sink fitting. Turn hot
water valve all the way open and
open your pressure valve (figure 9).
2. Open drain valve (figure 9) and in-
sert in sink, toilet or other drain.
3. Plug electric cord in grounded 3-
pin outlet.
IMPORTANT: The most common mis-
take made with this machine is forget-
ting to open the valves. Remember there
are valves at both ends of each hose (pres-
sure and drain). If any of these valves are
closed, the machine will not work.
E. Prespraying and Spotting Carpet:
1. Snap prespray hose quick connect
into the prespray plug (figure 10).
2. Prespray carpet with prespray wand
(figure 11). Concentrate prespray
on the main traffic areas and spots.
Prespray spots heavily and work in
by rubbing your foot over the
treated spot. Rinse spots thor-
oughly (3-4 cleaning passes) and
make a final dry pass.
3. With stubborn stains you may need
to boost your detergent. You can
do this with your spotting bottle
(figure 13). Simply spray stain with
your spotting bottle, work in, and
rinse thoroughly (3-4 cleaning passes
followed by a final slow dry pass).
III. Extraction Procedure
A. Before You Begin
Before starting your machine, famil-
iarize yourself with the control panel
(figure 14). This panel has 4 switches
and an indicator light.
• Vacuum Switch: This toggle switch
turns your vacuum motor on and off.
Sink Fitting
Pressure Valve
(open)
Drain Valve
(open)
Figure 8: Hoses Hooked to Sink
Drain
Drain
Valve
Valve
(closed)
(open)
Figure 9: Ball Valves (open and closed)
Prespray Bottle
Prespray Plug
Prespray
hose
Figure 10: Attaching Prespray Hose
Prespray
Wand
Prespray Hose
Figure 11: Prespraying Carpet
-3-
Garden Hose
Swivel Nut
Pressure
Valve
(closed)
Pressure
Valve
(open)
Prespray
Extension
Advertisement
Table of Contents
