Disassembly & Reassembly - Samsung 955MB Service Manual

3 Disassembly and Reassembly
This section of the service manual describes the disassembly and reassembly procedures for the
CA19JS monitor.
WARNING: This monitor contains electrostatically sensitive devices. Use with caution when
handling these components.
3-1 Disassembly
Cautions:1. Disconnect the monitor from the power source before disassembly.
2. To remove the Rear Cover, you must use the special opening jig tool.
3-1-1 Before Disassembly
1. Disconnect power cord from the monitor.
2. With a pad beneath it, stand the monitor on its
front with the screen facing downward and
the base close to you.
3-1-2 Cabinet Disassembly
1. Remove the Stand from the monitor.
(Refer to stand manual)
2. Remove 2 screws on the rear cover.
Figure 1
3. Tilt the monitor by lifting at the rear.
Figure 2
CA19JS
4. Push the opening jig in to each groove along
the side of the monitor until it makes a "ttak"
sound. (2 grooves : Left and right, make sure
each snap is disengaged.)
Figure 3
5. Pull the rear cover up and away from the
monitor.
Figure 4
CONFIDENTIAL
3-1