Table of Contents
Advertisement
Tool functions
1. Cut mooring rope with in 2 cm diameters. Cut flat woven bag with even fracture and no
thread loosing.
2. Cut the sewing tampons of cloth toys and ton bag with melt fracture.
3. It is most suitable to process sail cloth, awnings and filter cloth (synthetic fabrics with
thickness of 0.3mm or more). Cut all kinds of fabrics (clothing, banners, silk, chemical fiber
cloth, velvet, advertising cloth, non-woven, nylon fabric. Wallpaper mural plastic sheeting)it
will heal the contact area while cutting, which results in smooth and even cut surface, without
thread pulling or burrs by welding the interface, (note)coupled with incision blade, it can be
used to cut thin plastic sheet, or used in some simple cutting occasions, and for cutting
plasitc pipe.
Directions for use
Installation of the blade
1. When the tool is cool and not energized, unscrew the two nuts clamping the knife leg with
hexagonal wrench in counter-clockwise direction.
2. Insert two legs of the blade into the holes of the two cutting heads and then tighten the two
nuts to ensure knife legs and cutting heads in full contact.improper assembling would not
heat up the blade.
3. Turn on the power .
4. Adjust the temperature wheel, the higher the temperature if roated inward and the lower
the temperature with outward rotation.
Instructions for the cutting
1. Firstly, adjust the temperature wheel in the middle position, and set the blade on the
object. Turn on the shift and warm up the tool for seconds before cutting (recommend to test
on waste materials before cutting)
2. Secondly, keep the consistency of the temperature and speed. Too much fog might be
caused by slow speed or over temperature. This will lead to irregular and uneven cutting
track, which could resolved by cooling down the blade temperature or loosen the switch for
intermittence. Remember to release the switch before finishig the last 3-5cm. Besides, the
exposed part of the blade during cutting temperature and speed 2 cm. For overexposing
might lead to deformation of the blade. Proper cutting temperature and speed not only
improve the work efficiency but also extend the service life oh the tool.
04
JC MACHINERY & TOOLS INC.
Advertisement
Table of Contents
