Advertisement
ETHERNET BLACK BOX SONAR Installation Guide
S
T
ET UP
RANSDUCERS AND
Transducers with ID or XID (Airmar transducers) are configured automatically in the system, and the
control head will automatically select the best sonar source based on transducer capabilities. Sonar
source information is available in your control head operations manual.
NOTE: To set up a transducer manually (Initial Setup), change sonar sources, or troubleshoot
sonar sources, download the Transducer Setup Guide from our Web site at humminbird.com.
Open the Sonar Source Menu
Use the following instructions to open the Sonar Source Menu, where you can select sonar sources,
set the max depth and depth offset, and select other sonar settings for your connected transducers.
1. Press the HOME key.
2. Select Settings.
3. Select Sonar to access Noise Filter and individual Beam Select.
4. Select Sonar Source to set up transducers and choose sonar sources.
S
A
CHIRP S
ET
IRMAR
Use the following instructions to set up transmit mode, sweep, frequency range, and other operation
preferences. The menus in this section are determined by the type of CHIRP transducer installed.
1. Press the HOME key.
2. Select Settings.
3. Select Sonar.
4. Scroll to the CHIRP SONAR section to adjust the following menu settings:
Transmit Mode
Beam Select
Low/Medium/High
Frequency
Low/Medium/High
Frequency Spectrum
Noise Filter
S
S
S
ELECT
ONAR
OURCES
(
)
ETTINGS
OPTIONAL
Select Spectrum Sweep to transmit the transducer beams in a
sweeping range. To set the sweep range see Low/Medium/High
Frequency Spectrum.
Select Single Frequency to transmit the transducer beams at a
frequency set to your preference. To change the frequency, see
Low/Medium/High Frequency.
If the selected sonar source includes more than one beam, you can
select which beams will be displayed in the sonar view.
The control head will automatically select a frequency for each
transducer beam. Use the Frequency Menus to adjust each frequency
higher or lower. Transmit Mode must be set to Single Frequency to
access these menus.
For each sweep range, set the start frequency and the end frequency.
Transmit Mode must be set to Spectrum Sweep to access these
menus.
Use Noise Filter to limit interference on the sonar view from sources
such as your boat engine, turbulence, or other sonar devices.
(
)
OPTIONAL
5
531812-1_B
Advertisement
