Lindy 25115 User Manual

10/100BaseTX to 100BaseFX
Media Converter Series
User's Manual

Introduction

This Fast Ethernet Media Converter Series is
designed to bridge a 100BaseTX signal to a
100BaseFX signal. It's used to extend the distance
connection between two Fast Ethernet twisted-pair
devices via the fiber cable transparently with no
performance degradation.
This Media Converter Series is based on the
switching hub design.
Auto-Negotiation and Flow Control function on the
twisted-pair port. Besides, it can provide different
types of fiber connectors, such as SC, ST, MT-RJ
and LC for multi-mode or single-mode cables.

Package Contents

Before you start to install this Media Converter,
please verify your package that contains the
following items:
One Media Converter
One Power Adapter
One User's Manual
It can support
3

FCC Warning

This device has been tested and found to comply
with limits for a Class B digital device, pursuant to
Part 2 and 15 of FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference when the equipment is
operated in a commercial environment.
equipment generates and radiates radio frequency
energy and, if not installed and used in
accordance with the user's manual, it may cause
interference in which case users will be required to
correct interference at their own expenses.

CE Warning

This is a Class B product.
environment, this product may cause radio
interference in which case the user may be
required to take adequate measures.

Key Features

Compliant with IEEE 802.3 10BaseT and IEEE
802.3u 100BaseTX/100BaseFX Standards
One 10/100BaseTX Ethernet TP Port and One
100BaseFX Ethernet Fiber Port
One 100BaseFX Fiber Port can support either
Multi (SC/ST) or Single (SC, LC, MT-RJ) Mode
TP Port can support Half/Full-Duplex,
Auto-MDI/MDI-X and Auto-Negotiation
Providing a slide switch for Full- and
Half-Duplex selection on FX Port
Multiple Fiber Connectors
Providing 19" Converter Chassis for up to 16
slots with redundant power supply for optional
expansion use

Installation

DC Input & External Power Adapter
The External Power Adapter specification:
AC Input range from 90VAC to 260VAC
AC frequency range from 47Hz to 63Hz, TUV,
CE, UL Safety
Power Adapter DC Output is +5VDC 1.5A
The device DC Input is +5VDC 1A.

The TP Port

The device TP port
Auto-Negotiation and Flow Control functions. The
cable length is up
This
In a domestic
2
support Auto-MDIX,
to 100 meters for
4