Table of Contents
Advertisement
INSTALLATION / UN-INSTALLATION
Note
Before starting installation of the unit, make sure
the wiring is connected properly.
Use only the parts provided with the unit to ensure
proper installation.
The use of unauthorized parts may cause
malfunction.
Install the unit where it does not get in the driver's
way and will not injure the passenger in case
there is a sudden stop, like an emergency stop.
INSTALLATION
Put the 2 brackets to the left and right side of
the unit.
Use screws to fix the brackets to the unit.
Mounting Strap
A mounting strap id often included with new
stereos. For most installations, it is not necessary
part of the installation process. However, It can be
useful to help support the stereo in yr dash; it also
helps reduce vibration. One end of mounting strap
attaches (with a screw) to the rear of the stereo.
The other end attaches to an existing bolt or
screw behind the dash. Just bend the shape as
necessary to enable mounting.
WIRING CONNECTIONS
Make sure you have good chassis ground. A
good ground connection will eliminate most
electrical noise problems. A good chassis
ground requires a tight connection to the
vehicle's metal chassis. The area around the
ground connection should be clean, bare metal
without rust, paint, plastic, dust, or dirt for a
good electrical connection.
Caution: Do not interchange the connection of
the wiring!!!
For some car models you may need to modify
wiring of the supplied power cord. Contact your
authorized car dealer before installing this unit.
Using the power connector
Cut the connector; connect the colored leads of
the power cord to the car battery as shown in
the color code table below for speaker and
power cable connections.
M5x6mm
6
1
3
5
7
39
41
9
11
13
15
17
19
21
23
25
27
29
31
33
35
37
10
12
14
16
18
20
22
24
26
28
30
32
34
36
38
2
4
6
8
40
42
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
