Programming: Software Upgrade And Flexing; Related Publications - Motorola V235 Service Manual

Level 1 and 2 Service Manual
Table 4. Level 1 and 2 Troubleshooting Chart (Continued)
SYMPTOM
8. Phone does not sense when flip is
opened or closed (usually indicated by
inability to answer incoming calls by
opening the flip, or inability to make
outgoing calls).
10. Internal Charger not working.
11. Real Time Clock resetting when
standard battery is removed.
12. No or weak audio when using
headset.

Programming: Software Upgrade and Flexing

Related Publications

Motorola V235 User's Guide, English
6809495A43-C
PROBABLE CAUSE
a) Transceiver board assembly
defective.
Faulty charger circuit on transceiver
board assembly.
Lithium button cell in the display
board may be depleted.
a) Headset not fully pushed home.
b) Faulty connector socket on
transceiver board assembly.
Contact your local technical support engineer for information about equipment and
procedures for flashing and flexing.Part Numbers
The following information is provided as a reference for the parts associated with
V235 telephones.
Replace the transceiver board assembly (refer
to 1c). Verify that the fault has been cleared
and reassemble the unit with the new
transceiver board assembly.
Test a selection of batteries in the rear pocket
of the desktop charger. Check LED display for
the charging indications. If these are charging
properly, then the internal charger is at fault.
Replace the transceiver board assembly (refer
to 1c). Verify that the fault has been cleared
and reassemble the unit with the new
transceiver board assembly.
Refer service to a Level 3 service center for
replacement.
Ensure the headset plug is fully seated in the
connector socket. If fault not cleared, proceed
to b.
Replace the transceiver board assembly (refer
to 1c). Verify that the fault has been cleared
and reassemble the unit with the new
transceiver board assembly.
April 03, 2006
Troubleshooting
VERIFICATION AND REMEDY
SJJN6409A (6809482A70)
47