3Com AP3850 Quick Installation Manual page 17

Industry Canada – RF
Compliance
Declares that the Product:
Brand Name: 3Com Corporation
Model Number: AP3850
Equipment Type: WLAN Managed Access Point AP3850
Complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
3Com WLAN Managed Access Point AP3950
Model AP3850
This device complies with RSS 210 of Industry Canada.
Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of this device.
L ' utilisation de ce dispositif est autorisée seulement aux conditions
suivantes: (1) il ne doit pas produire de brouillage et (2) l' utilisateur du
dispositif doit étre prêt à accepter tout brouillage radioélectrique reçu,
même si ce brouillage est susceptible de compromettre le
fonctionnement du dispositif.
The term "IC" before the equipment certification number only signifies
that the Industry Canada technical specifications were met.
To reduce potential radio interference to other users, the antenna type
and its gain should be so chosen that the equivalent isotropically
radiated power (EIRP) is not more than that required for successful
communication. To prevent radio interference to the licensed service,
this device is intended to be operated indoors and away from windows to
provide maximum shielding. Equipment (or its transmit antenna) that is
installed outdoors is subject to licensing.
Pour empecher que cet appareil cause du brouillage au service faisant
l'objet d'une licence, il doit etre utilize a l'interieur et devrait etre place
loin des fenetres afin de Fournier un ecram de blindage maximal. Si le
matriel (ou son antenne d'emission) est installe a l'exterieur, il doit faire
l'objet d'une licence.
High power radars are allocated as primary users of the 5.25 to 5.35
GHz and 5.65 to 5.85 GHz bands. These radar stations can cause
interference with and/or damage this device.
This device must not be co-located or operated in conjunction with any
other antenna or transmitter.
The band 5150-5250 MHz is only for indoor usage to reduce the potential
for harmful interference to co-channel mobile satellite systems.
This device has been designed to operate with the antennas listed at the
start of the Regulatory Information section above, and having a
maximum gain of 6 dB (2.4GHz) or 8dB (5GHz). Antennas not included
in this list or having a gain greater than 6 dB (2.4GHz) or 8dB (5GHz)
are strictly prohibited for use with this device. The required antenna
impedance is 50 ohms.