Advertisement
Programming Instruction
1. Press PMode(Fn + Pn) to enter the programming mode (Pn LED flashing)
2. Press the key you want to program (Pn LED on)
3. Key in the programming content and then press Pn (Pn LED flashing again)
4. Repeat steps 2 and 3 to program additional keys
5. Press PMode(Fn + Pn) to exit programming mode (Pn LED off)
Note:
While in SELECT state (step 1), you can press Pn + any key to view it's content in any word
processing software (e.g. Notepad)
Supports time delay: press 15ms key(Fn + Ins) to delay 15ms, press 0.1s key(Fn + Home) to
delay 0.1s, press 0.5s key(Fn + PgUp) to delay 0.5s. Consecutive delays will add up, but will
only be counted as 1 key stroke.
Each key can program up to 64 key strokes
If no key is pressed for 15s while in programming mode, keyboard will exit to normal mode
Programming Usage
Press Pn + Programmed key, OR
Press Toggle (Two arrow keys) to light up the Toggle LED first, then press the programmed key. If
you press PN + Programmed key at this moment, it will output the original key code.
Programming Examples
1. Program A as 123: Fn + Pn, A, 1, 2, 3, Pn
2. Continue to program B as Ctrl + C: B, Ctrl + C, Pn
3. Continue to program C to CMD in Win7: Win, C, Fn + Home, M, Fn + Home, D, Fn +PgUp,
Enter, Pn
4. Finish programming: Fn + Pn
5. Invoking programmed A: Pn + A => Output 123
6. Invoking programmed C: Pn + C => Running CMD.EVE
7. Switch to Pn layer: Toggle (two arrow keys) => Toggle LED on
a. Invoking programmed B: B => Output Ctrl + C (Same as copy)
b. Invoking programmed C: C=> Running CMD.EXE
c.
If you need to get the A back (pressing A currently => 123): Pn + A => A
Rollover Mode Switch
Press Nkey (Lightning key), the Nkey LED will be flashing while switching. Nkey LED is lit for N-key
rollover mode. Nkey LED is off while in 6-key rollover mode.
Advertisement
