Operating Instructions - Jenn-Air DU506 Repair Manual

How to operate your dishwasher
,rVent DoorLatch (Locked) CycleIndicator Dial
(Turn toStart)
, / I I
CYCLE S ELECTOR S_ w_,_ CONIROL CENTER/
r 7171 rT1
P_rE
X
STEP 1. Load your dishwasher STEP 4. Select the Cycle and start To obtain the benefits of a complete
with dishes, silverware, pots, pans, dishwasher. (See Cycle selection cycle, be careful that you do not
bowls, etc. according to hints on next page.) turn the dial any further than
instructions on pages 8 and 9. If your dishwasher drains into a necessary to start the dishwasher.
STEP 2. Add detergent to the food waste disposer, operate the • For SHORT WASH cycle:
detergent dispenser. Make sure the disposer until it is empty before
SHORT WASI_
Cycle Indicator Dial is at OFF starting the dishwasher.
position before adding detergent. • For SUPER SCRUB, StARt
See pages 6 and 7. NORMAL WASH and OFF
Use rinse aid agent to help prevent LIGHT WASH cycles: R,NSE
aHOLO
spotting. Occasionally check to
make sure the rinse agent container SUPER NORMALLIGHT pLATE
is at least half full. See page 6. SCRUB WASH WASH
STEP 3. Select Drying Option. _ a. Be sure door is unlatched.
LL..£.J b. Slowly turn Cycle Indicator Dial
HOT COOL
to SHORT WASH position.
DRY DRY
c. Latch door to start the cycle.
a. Push selected cycle button. • For RINSE & HOLD cycle:
b. Latch the door. SHORTWAS H
HOT DRY. Turns the drying heater StARt
on for fast drying, o_ R,,_ _.oto
COOL DRY (no-heat drying). RI.SE • HOt.O PLATE
Turns the drying heater off to save
pLATE
energy. Dishes dry naturally over a a. Be sure door is unlatched.
longer period such as overnight. Do not use detergent.
c. Slowly turn Cycle Indicator Dial b. Select COOL DRY drying
If you need your dishes sooner, to START position to start the
open the dishwasher door after the cycle. You will hear the motor option.
cycle is complete to reduce the start. There is a time delay c. Slowly turn Cycle Indicator
natural drying time. between start-up and water fill Dial to RINSE & HOLD
Use of this option reduces the so you will not hear any wash position.
electrical energy used by this action right away. d. Latch the door to start the cycle.
model approximately 8 % for
Normal Wash cycle.
4