Yaesu BH-1 Owner's Manual

When the optional BU-1 Bluetooth
set as a wireless link to send and receive audio to the Transceiver*.
Controls & Connections
Microphone
POWER switch
VOLUME ( – ) switch
VOLUME ( + ) switch
LED Indicator
Blinking Blue: When the BH-1 Bluetooth
set is correctly recognized by the
transceiver.
Blinking Red: When the BH-1 Bluetooth
set is not correctly recognized by
the transceiver.
Blinking Red/Blue: Battery Voltage is Low.
PTT switch
Press this key to transmit. Release this key to return to
receive.
Earphone jack
If you use the Marine Transceiver, the BH-1 is not pos-
sible to listen to the stereo signal.
SPEAKER
Earhook
You can wear the BH-1 on your left or right ear.
Pairing
Before you can use your BH-1 for the first time, the BH-1
and the transceiver must be paired.
Refer to the BU-1 Bluetooth
ing instructions.
Please bring the BH-1 and the Transceiver close together
when doing Pairing.
1. Make sure that the BH-1 is off.
2. Press and hold the POWER switch for five seconds, until
the LED indicator blinks red/blue alternately.
When the BH-1 is correctly recognized (Requires a 20 to 30
seconds) by the transceiver, the LED indicator will blink
blue.
LED indicator
POWER Switch
Marine Division of VERTEX STANDARD
US Headquarters
10900 Walker Street, Cypress, CA 90630, U.S.A.
www.standardhorizon.com
E A F
"BH-1" Bluetooth
®
Adapter Unit is installed, you may use the optional BH-1 Bluetooth
Head-
®
Head-
®
® Adapter Unit Manual for Pair-
4 4 U 7 5 0
Head Set
®
* Check with your Vertex Standard Dealer or Catalog for applicable models.
BH-1 is not designed to attach to a helmet.
Specifications are subject to change without notice.
Turning ON and OFF
T T T T T o turn the o turn the BH-1 ON o turn the o turn the
o turn the
Press and hold the POWER switch for three seconds, until
the BH-1's LED indicator glows red, and the beeper sounds
a high pitch tone.
When the BH-1 is correctly recognized by the transceiver,
the LED indicator will blink blue.
When the BH-1 is not correctly recognized by the trans-
ceiver, the LED indicator will blink red.
T T T T T o turn the o turn the BH-1 OFF o turn the o turn the
o turn the
Press and hold the POWER switch for five seconds, until
the BH-1's red LED indicator blinks rapidly, the beeper
sounds two brief tones, and the BH-1 turns off.
Note Note
Note : The BH-1 is automatically turned off when it is in- Note Note
serted into the CAB-2 charger.
Effective Communications Range
The communications range between the BH-1 and the
Transceiver is around 10m (33 ft).
Obstacles between the BH-1 and the Transceiver may
shorten the communications distance.
If you move out of range, the beeper sounds a low pitch
tone. If you move back into range, the beeper sounds a
high pitch tone.
ON ON ON
ON
OFF OFF OFF
OFF
POWER Switch
®
Head-