IP SPEED DOME CAMERA
Quick Start Guide
■ Please read this instruction carefully for correct use of the
product and preserve it for reference purposes.
■ All the examples and pictures used here are for reference
only.
■ There may be several technically incorrect places or printing
errors in this manual. The updates will be added into the new
version of this manual. The contents of this manual are subject
to change without notice.
1. Interfaces and Parts
1
2
3
① LAN
4
② HP Audio Out
5
③ MIC In
④ Alarm In/Alarm Out
⑤ Power
Note: DC24V and AC24V power supply
are optional. Please take real camera as
standard.
2. Installation
Please make sure the wall is strong enough to bear the dome
camera's weight. Please make sure the camera is powered off
during installation.
◆ Install SD Card
Rubber Plug
Rubber Plug
Side Cover
① Pull out the rubber plugs and then
② Loosen the four screws of the back cover
loosen the screws under the rubber
of the dome.
plugs to remove the side covers .
1
Insert SD card
④ Install the back and side covers. The reset
③ Open the back cover and insert SD card.
hole in the back cover must be aimed to the
reset key of the mainboard when installing
the back cover.
◆
Install the Speed Dome
① Pull the cables through the bracket. Mount the
② Secure the speed dome to the bracket with
speed dome to the bracket.
the screws.
③ Drill the screw holes on the wall according
④ Drive the two screws to the holes indicated
to the drill template. Then insert the plastic
by the arrows (left) and leave 12mm
plugs into the holes.
clearance.
⑤
⑥
Connect the cables and then hang the
bracket on the wall .
screws.
3. Connections
2
Reset
Alarm Connection:
1. Alarm Input
a) There is one independent alarm input port (ALM-IN1) and
one grounding port (ALM-GND).
b)Alarm input(NO type): Connect DC5V~DC12V voltage
between the alarm input port( ALM-IN1) and the grounding port
(ALM-GND).
c) Alarm input(NC type): Disconnect the voltage between the
alarm input port(ALM-IN1) and the grounding port (ALM-GND).
2. Alarm Output
a) Support 1CH alarm output including OPEN, COM
connections.
b) Alarm output: One passive switch for user to connect alarm
devices; the alarm output state will be auto on/off according to
your setting.
4. IE Network Connections
In LAN, there are two ways to access. a. Access through
IP-Tool; b. Directly Access through IE Browser
●
Access the camera through IP-Tool
① Make sure that the camera and the PC are well connected
to the LAN.
Fix the bracket to the wall with four
② Find the IP-Tool from the CD and then install it in the PC.
After that, run the IP-Tool as shown below.
ALM-OPEN
ALM-COM
ALM-GND
ALM-IN1
DC24V
Power
AC24V
24V A
Earth
24V B
3