Related Manuals for Accuris E2301 Series
Summary of Contents for Accuris E2301 Series
- Page 1 Service and Contact: Series E2301 300V Power Supply Operating Manual Version 3.18 Software rev. 1.8 A division of This product is for research only...
-
Page 2: Table Of Contents
8. Maintenance Always disconnect the power cord for cleaning. When cleaning the surfaces of the instrument, use a lightly dampened cloth with mild detergent if needed. Do not use any corrosive solutions that could damage plastic. Contents 1. Introduction………………………………………....1 Use caution when cleaning near the housing vents. Do not allow liquid to enter the power supply. -
Page 3: Introduction
1. Introduction Thank you for purchasing the Accuris myVolt Touch™ 7. Overview of Electrical Principles Electrophoresis Power Supply with touch screen control. Definitions: This operating manual includes a product introduction, and important operating and safety information. Before using the Voltage: The amount of potential energy between two power supply, please read this manual in its entirety to points in a circuit. -
Page 4: Product Overview
2. Product Overview In CONSTANT CURRENT mode, the power supply will output 4 Pairs of the set mAmp current parameter, and the voltage will fluctuate Touch Screen Electrical Outputs relative to the resistance of the load (buffer concentration in the Control and Display attached electrophoresis tanks) up to a maximum of the voltage setting that has been chosen. -
Page 5: Specifications
6.2 Setting Parameters 3. myVolt Touch Specifications The myVolt Touch Power Supply has 3 main parameters that can be adjusted: Run Time (TIME), Voltage (VOLTAGE), and Current (mAMP). myVolt Touch, Model E2301, 300V Power Supply (See section 7 for an overview of Voltage, Current, Resistance, and Output Voltage 10 to 300 VDC, in 1 V increments Power) -
Page 6: Installation
5. Warnings 4. Installation To avoid electrical shock, do not use this product with wet hands and ensure that all electrical leads being used are Place the power supply on a smooth, level surface in an area dry. Only use electrical leads that offer sufficient where it will not contact liquids or chemicals.