Whirlpool 3LWED4800 Use And Care Manual page 9

3.
Select the desired cycle
Appearance may vary
Select the desired cycle for your load. See the Cycle Guide
for more information about each cycle.
AUTOMATIC DRY Cycles
You can select a different dryness level, depending on your
load, by turning the knob to the appropriate Automatic Dry
cycle.
Selecting an Automatic Dry cyle automatically adjusts the
dryness level at which the dryer will shut off. Once a dryness
level is set, it cannot be changed without stopping the cycle.
AUTOMATIC DRY cycles give the best drying in the shortest
time. Drying time varies based on fabric type, load size, and
dryness setting.
NOTE: ENERGY PREFERRED is used for a starting point for
AUTODRY cycles. Choose ENERGY PREFERRED for optimal
energy savings.
4.
Set cycle settings and options
(on some models)
Select cycle settings and options by turning the knob to the
desired position.
5.
Select End of Cycle Signal
(if desired)
Turn the END OF CYCLE SIGNAL knob to select the desired
setting (On or Off). The End of Cycle Signal produces an
audible sound when the drying cycle is finished. Promptly
removing clothes at the end of the cycle reduces wrinkling.
NOTE: When the Wrinkle Shield setting is selected and
the End of Cycle Signal is on, the tone will sound every
5 minutes until the clothes are removed, or the Wrinkle
Shield setting ends.
6.
Press PUSH to START to
begin cycle
Push and hold the PUSH to START knob to begin the cycle.
Promptly remove garments after cycle has completed to
reduce wrinkling. Use the Wrinkle Shield feature to avoid
wrinkling when you are unable to remove a load from the
dryer as soon as it stops.
9