Do you have a question about the 503 and is the answer not in the manual?
Questions and answers
Le houezec
March 26, 2025
Mettre l aiguilles au centre
1 comments:
Mr. Anderson
March 26, 2025
To center the needle on a Frister Rossmann 503 sewing machine, use the Needle Position Control and set it to "M" (middle position).
This answer is automatically generated
Le houezec
March 26, 2025
Réglage de l' aiguille du point droit
1 comments:
Mr. Anderson
March 26, 2025
To adjust the needle for a straight stitch on the Frister Rossmann 503:
1. Use the needle plate insert with the small round hole. 2. Set the stitch length control to the desired length. 3. Ensure the needle position control is set correctly. 4. Adjust the upper thread tension if needed to achieve a balanced stitch. 5. If necessary, adjust the bobbin tension slightly using a screwdriver. 6. Raise the needle to its highest position and raise the presser foot before making changes.
This answer is automatically generated
Rita Loring
July 19, 2025
Needle does not pick up bobbin thread. Cotton appears to be pulled through the bobbin correctly and pulls through, a small length of thread is left when the bobbin is replaced. What am I doing wrong?
Need help?
Do you have a question about the 503 and is the answer not in the manual?
Questions and answers
Mettre l aiguilles au centre
To center the needle on a Frister Rossmann 503 sewing machine, use the Needle Position Control and set it to "M" (middle position).
This answer is automatically generated
Réglage de l' aiguille du point droit
To adjust the needle for a straight stitch on the Frister Rossmann 503:
1. Use the needle plate insert with the small round hole.
2. Set the stitch length control to the desired length.
3. Ensure the needle position control is set correctly.
4. Adjust the upper thread tension if needed to achieve a balanced stitch.
5. If necessary, adjust the bobbin tension slightly using a screwdriver.
6. Raise the needle to its highest position and raise the presser foot before making changes.
This answer is automatically generated
Needle does not pick up bobbin thread. Cotton appears to be pulled through the bobbin correctly and pulls through, a small length of thread is left when the bobbin is replaced. What am I doing wrong?