Advertisement
3 channels on each Code Adjustment set. Change code set by moving switch from A-D.
Remote has ALL ON or ALL OFF function. The bottom buttons on the remote control are set to ALL ON or
ALL OFF and you cannot learn another socket on these buttons.
DELETING A PAIRED SOCKET
1. To delete certain socket from the remote control, remove the socket and disconnect from the power for
5 seconds.
2. Reconnect the power to the socket and the socket will enter Learning Mode again.
3. Now press the OFF button to delete the socket.
NOTE: You can repeat this step to delete all 12 channels code.
4. If you want to delete a certain code learned before then you can press the ON and OFF button together
for around 5 seconds
5. The Socket LED will blink and enter into learning mode, and then press OFF button to delete the code.
DELETING ALL SOCKETS
1. To delete all sockets from the remote control, then you can press the ON and OFF button together for
around 5 seconds
2. The Socket LED will blink and enter into learning mode, and then press ALL ON and ALL OFF buttons to
delete the code.
If you have any queries about this product, there are three ways to contact our customer service department:
To find more details on a wide range of Rapid Response products please visit our website at www.lloytron.com
Lloytron plc, Laltex House, Leigh Commerce Park, Greenfold Way, Leigh, Lancashire, WN7 3XH. England, U.K
CUSTOMER SERVICES
08454 81 8808
customerservice@lloytron.com
www.lloytronhelpdesk.com
Advertisement
