Download Print this page

Gioteck GC-1 Manual

Bluetooth controller for playstation 3

Advertisement

Quick Links

GC - 1
preCautions
This product has been designed with
the highest concern for safety. However,
any electrical device, if used improperly,
has the potential to cause harm. To help
BLUETOOTH® CONTROLLER
ensure risk-free operation please pay
FOR PLAYSTATION 3™
attention to the following guidelines.
Thank you for purchasing
• Use only as intended. This is a precision
the GC-1 Bluetooth Controller
product, handle with care.
from Gioteck.
• Contains small parts. Not suitable for
children under 3 years of age.
We hope that this product will
• Store in a dry & dust free area.
go beyond your expectations for
Do not store in areas of extreme heat or
a quality made accessory.
cold, and avoid direct sunlight or heat
sources eg. heaters.
Please read this booklet
• Do not allow the product to get wet or dirty;
thoroughly before using the
doing so may cause damage.
product and review the PS3™
• Do not clean with benzene, paint thinner,
manual for additional details
acetone, alcohol, or other such solvents.
regarding PS3™ operation.
• Do not take the product apart; doing so
will void your warranty and may cause
Thank you & enjoy!
electrical shock.
gb
01 | Home Button
02 | Select Button
03 | Turbo Button
04 | Start Button
05 | L3 Thumbstick
06 | Function Buttons
07 | Directional Pad
08 | R3 Thumbstick
09 | LED feedback
10 | R1 Button
11 | R2 Button
12 | L1 Button
13 | L2 Button
14 | Mini-USB Port
15 | Flip Switch
16 | Battery Compartment
10
14
11
es
Fr
01 | Touche Home
01 | Botón Home
02 | Touche SELECT
02 | Botón SELECT
03 | Touche Turbo
03 | Botón Turbo
04 | Touche START
04 | Botón START
05 | Touche L3
05 | Botón L3
06 | Touches de fonction
06 | Botones de función
07 | Touches directionnelles
07 | Botones de dirección
08 | Touche R3
08 | Botón R3
09 | DEL de retour
09 | Indicador LED
10 | Botón R1
10 | Touche R1
11 | Touche R2
11 | Botón R2
12 | Touche L1
12 | Botón L1
13 | Touche L2
13 | Botón L2
14 | Port mini-USB
14 | Mini conector USB
15 | Touche d'inversion
15 | Interruptor de cambio
16 | Compartiment des piles
16 | Compartimento de pilas
De
it
01 | Tasto HOME
01 | Home-Taste
02 | Select-Taste
02 | Tasto SELECT
03 | Turbo-Taste
03 | Tasto TURBO
04 | Start-Taste
04 | Tasto START
05 | L3-Thumbsti
05 | Tasto L3
06 | Funktionstasten
06 | Tasti funzione
07 | Steuerkreuz
07 | Tasto direzionale
08 | R3-Thumbstick
08 | Tasto R3
09 | LED-Feedback
09 | LED di stato
10 | R1-Taste
10 | Tasto R1
11 | R2-Taste
11 | Tasto R2
12 | L1-Taste
12 | Tasto L1
13 | L2-Taste
13 | Tasto L2
14 | Mini-USB-Port
14 | Connettore Mini-USB
15 | Kippschalter
15 | Interruttore di scambio
16 | Alloggiamento della batteria
16 | Batteriefach
warnings
This symbol indicates important
installation, operational or
maintenance instructions.
Always follow these
instructions closely.
environment
Please help to conserve
the environment by recycling
the cardboard packaging of
this product.
This product should NOT
be disposed of in normal
household waste. It should
be disposed of separately.
Please take it to an electrical
waste collection point.
troubleshooting
Having trouble? For further assistance
please contact our customer support team
on our website: www.gioteck.com
09
06
05
02
04
03
07
08
01
15
12
13
16
pt
01 | Botão Home
02 | Botão SELECT
03 | Botão Turbo
04 | Botão START
05 | Manípulo Analógico L3
06 | Botões de Função
07 | Botões Direccionais
08 | Manípulo Analógico R3
09 | Aviso LED
10 | Botão R1
11 | Botão R2
12 | Botão L1
13 | Botão L2
14 | Porta Mini-USB
15 | Interruptor
16 | Compartimento das Pilhas
CZ
01 | Tlačítko Domů
02 | Tlačítko Vybrat
03 | Tlačítko Turbo
04 | Tlačítko Start
05 | Tlačítko L3
06 | Funkční tlačítka
07 | Směrová podložka
08 | Tlačítko R3
09 | Podsvícením LED
10 | Tlačítko R1
11 | Tlačítko R2
12 | Tlačítko L1
13 | Tlačítko L2
14 | Mini USB port
15 | Spínač
16 | Prostor pro baterie
legals
not installed correctly, may cause harmful
This product complies with the following
interference to radio communications. This
legal regulations. For further information
go to www.gioteck.com
equipment has been tested and found to
comply with the limits for a Class B digital
Caution: The user is cautioned that
device, pursuant to part 15 of the FCC
changes or modifications not
Rules. These limits are designed to provide
expressly approved by the party responsible
reasonable protection against harmful
for compliance could void the user's
interference in a residential installation. If this
authority to operate the equipment. This
equipment does cause harmful interference
device complies with Part 15 of the FCC
to radio/television reception try the following:
Rules. Operation is subject to the following
• Reorient or relocate the receiving antenna.
two conditions: (1) this device may not
• Increase the separation between the
cause harmful interference,and (2) this
equipment and receiver. • Connect the
device must accept any interference
equipment into an outlet on a circuit different
received, including inter-ference that may
from that to which the receiver is connected.
cause undesired operation. However, there
• Consult the dealer or an experienced radio/
is no guarantee that interference will not
TV technician for help. This equipment
occur in a particular installation. The device
complies with FCC radiation exposure limits
and its antenna must not be co-located
set forth for an uncontrolled environment.
or operating in conjunction with any other
End user must follow the specific operating
antenna or transmitter. Gioteck are not
instructions for satisfying RF exposure
responsible for any interference caused by
compliance. This transmitter must not be co-
un-authorized changes to this equipment.
located or operating in conjunction with any
This equipment generates, uses, and can
other antenna or transmitter.
radiate radio frequency energy and, if
1. set up
Using the controller wired
Connect the USB to the PS3 and the
mini USB to the controller's charging
01
socket. Note:The GC-1 does not need
to contain batteries to function as a
wired device.
02
Using the controller wirelessly
1 ) Insert 2 x rechargeable batteries
or a battery pack.
2 ) Connect your controller to the PS3
via a USB cable and pairing will happen
automatically. The pairing process can
take up to 10 seconds.
3 ) To charge your controller connect
your controller to the PS3 via USB.
4. turbo FunCtion
5. Flip switCh
Pressing an action button assigned
To swap the functions assigned to the
with turbo will simulate the button being
L1 & L2 and R1 & R2 buttons simply
pressed rapidly e.g. "boost firepower".
slide the switch from left to right.
To enable turbo: Press & hold Turbo then
press the action button you wish to turbo.
To disable turbo: Repeat the steps above.
More than one button can be
assigned the turbo function at
any one time.
Gioteck hereby declares that this
controller is in compliance with the
essential requirements and other provisions
of Directive 2004/108/EC. To view the full
version of the Declaration of Conformity
please go online to doc.gioteck.com
GC-1
TouchSense® Technology Licensed from
Immersion Corporation. Protected by one
BLUETOOTH®
or more of the following patents: U.S.
CONTROLLER
PATENTS: 5831408, 5844392, 5857986,
5907487, 5959613, 6020875, 6088017,
FOR PS3™
6104158, 6219032, 6246390, 6252583,
6271833, 6275213, 6278439, 6343349,
6400352, 6411276, 6424333, 6715045,
6801008, 7131073, 7199790, 7209117,
7299321, 7327348, 7345672, and 7502011.
3. assigning ports
2. operation
To power on your controller, press the
Once paired one or two LEDs within
home button for 1 second until a red
the crescent of the controller will light
LED appears in the crescent.
depending on which port the controller
To power off your controller, press and hold
has been assigned to.
the home button for 5 seconds.
To assign your controller to a different
Sleep mode: The GC-1 will go
port, go to: Accessory Settings >
into sleep mode if not used for
Reassign Controller and scroll to assign
5 mins. To wake the controller,
the controller to your desired port.
press the HOME button.
6. thumbstiCK Calibration
The GC-1 has calibrated thumbsticks that
will sharpen aim and improve accuracy
during serious FPS gameplay.
If would like to change the thumbstick
sensitivity, download the latest Gioteck
software from the GC-1 support pages
on our website: www.gioteck.com
FOR TROUBLESHOOTING &
VIEw THIS MANUAL ONLINE:
www.gioteck.com
.

Advertisement

loading
Need help?

Need help?

Do you have a question about the GC-1 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Gioteck GC-1

  • Page 1 USB to the controller’s charging LED appears in the crescent. depending on which port the controller 04 | Start Button socket. Note:The GC-1 does not need To power off your controller, press and hold has been assigned to. 05 | L3 Thumbstick to contain batteries to function as a the home button for 5 seconds.
  • Page 2 El GC-1 no necesita pilas para collegato fisicamente, il controller GC-1 non ha bisogno di prise de recharge de la manette. La GC-1 n’a pas besoin de der Ladebuchse des Controllers. Der GC-1 benötigt keine carregamento do comando. O GC-1 não precisa de pilhas chcete-li Používat ovladač...