Casio SE-G1 Quick Programming Manual

"
6
6
Casio SE-G1 Australian Quick Programming Guide
(please also refer to the "User Manual" supplied for further information if required)
1
Load Memory Protection Batteries and Paper Roll
Load Memory Protection Batteries and Paper Roll
Insert 2 new "AA" type batteries
A) Remove the printer cover
B) Open Battery C)
Compartment cover into the compartment
1
IMPORTANT: Confirm that the plus (+) and minus (-) ends of the batteries
are facing in the directions indicated in the illustration inside the
battery compartment.
2
Initialize Your Cash Register
A) B) Plug the power cord into the AC outlet and wait for
Insert the supplied key and turn
to the "OFF" position. the instructional messages to print.
3
Choosing the Language
A) For English select the following:
Please also refer to printout instructions from the cash register
4
Setting Date and Time
A) Input date and time as indicated on the printout chit on the cash
register
6
Setting for Australian Standards
A) Turn key to the Z position
Perform the following sequence
B)
Note: This operation automatically sets correct tax
rates, rounding, and receipt formats to Australian
standards.
To prevent losing all of your settings and sales
data, we recommend you install the two memory
protection batteries.
D) Install the supplied thermal paper roll by lifting up the
platen arm and placing the paper roll into the printer well as
shown below. Close the cover firmly.
5
Printer switch for receipt or journal
To set for Receipt printing:
Turn key to the PGM position
A)
B) Perform steps as follows:
To set for Journal printing:
A) Turn key to the PGM position
Perform steps as follows:
B)
7
Setting GST to Departments
To enable
A) Turn key to the PGM position
If using shift departments
B) Press
otherwise skip this step
C) Press
then press departments as required
D) Press
To disable use same sequence except use
in place of