Turning Power On/Off; Changing Screen Display To English; Making Initial Setting - Docomo SH-04A Instruction Manual

Power ON/OFF

Turning power ON/OFF

Turning power ON
Press H (for 2+ seconds).
1
: It may take some time for the wakeup screen to appear.
: The wakeup screen appears followed by the initial settings screen.
Proceed to Initial setting (nP. 50).
: If initial settings have been completed, the
screen shown on the right appears when power
is turned on. This screen is called the "stand-by
display".
Welcome mail
: "Welcome$
(Welcome$Decome-Anime%&) and "
Early Warning "Area Mail") are saved by
default.
: To check a welcome mail: In stand-by, select
the stock icon C (mail message).
• For details on the following operations
nP. 143
If initial settings are not yet completed, the setting screen appears every
time the power is turned on.
If the FOMA card is not inserted, [Insert UIM] and a FOMA card error
appear (nP. 30).
When [Enter PIN1 code] appears, enter the PIN1 code (nP. 114).
When a FOMA card is replaced with a new card, the terminal security
code (four to eight digits) must be entered after turning on the terminal.
If a correct terminal security code is entered, stand-by display appears.
When a wrong terminal security code is entered five times, the power is
turned off. However, turning on the power again is possible.
When A appears, the handset is outside the service area or in a place
with no signal. Move to a place where the icon disappears.
50
%&"
" (Information of
Stand-by display
Turning power OFF
Press H (for 2+ seconds).
1
: It may take some time for the power to be turned off (The end screen
appears on the display until the power is turned off).
Select language

Changing screen display to English

1
In the Custom menu, select [
[Bilingual]/[English].
: To switch the display language from English to Japanese: In the
Custom menu, select [Settings]/[General settings]/[Select
language]/[ ].
If a FOMA card is inserted, settings are saved to the FOMA card as
well. When the setting of the FOMA terminal handset and the setting of
the inserted FOMA card are different, the setting in the FOMA card is
prioritized.
Initial setting

Making initial setting

The initial settings screen appears automatically when the power
is turned on for the first time. Each setting item can also be set
from Menu (When the initial settings are complete, the stand-by
display appears).
Date and time settings
Key/Touch sound
Font size settings
When items that have not been set remain, the setting screen appears
every time the power is turned on.
1 Set the date and time (nP. 51).
2
Register a terminal security code (nP. 113).
3 Set the Key/Touch sound (nP. 96).
]/[ ]/
Change terminal security code
Location request menu