Advertisement
digiprint - Getting Started...
Prerequisites
Your digifobpro must be running rmware 2.0 or later. You can check this by
navigating to the 'Maintenance - About' menu item on your digifobpro.
Your digifobpro client software, digiconnect or digifobpro Connect must be
version 2.04 or later. You can check this by Right – Clicking on your client
software Icon in your PCs system tray and navigating to the 'About' option.
Please check www.Tachosys.com for the latest software updates and
downloads.
Enabling printing within your digifobpro
By default your digifobpro is not enabled for printing. To enable the print
functionality you must connect your digifobpro to the PC. See ' Connecting the
Digifobpro to your PC' in your digifobpro User Guide.
Once connected Right-Click on the digiConnect icon in your system tray
bottom right of your screen and select 'Con gure Device'. Tick the box
adjacent to the label 'Enable use of digiPrint' (see Fig 1 below) and then Click
'Apply'. If you do not have this option within digiConnect then your
digiConnect requires upgrading, see 'Prerequisites' above.
digiprint User Instructions
Inserting the paper roll
To access the paper roll compartment gently lift the tab shown in Fig 2. this
should open the compartment and allow you to pull the cover backwards. The
compartment is hinged from the top edge. Be careful not to put excessive force
on the opening tab.
Hinge point
The paper roll should be inserted as indicated in Fig2. Excess paper should be
torn o by applying pressure against the serrated paper cutter.
Charging the digiprint
Before you use your digiprint for the rst time, ensure that it is fully charged.
The power supply has an LED indicator which shines RED when the unit
Fig 1
requires further charge and GREEN when the unit is fully charged.
NB: You cannot use the
digiprint whilst it is charging.
digifobpro
connection
Page - 2
Digiprint User Instructions
Fig 2
Paper Cutter
Fig 3
Charge socket
ON/OFF switch
Ready indicator LED
Paper feed button
Page - 3
Advertisement
