Summary of Contents for Tachosys digiprint
- Page 2 ‘Con gure Device’. Tick the box The paper roll should be inserted as indicated in Fig2. Excess paper should be adjacent to the label ‘Enable use of digiPrint’ (see Fig 1 below) and then Click torn o by applying pressure against the serrated paper cutter.
- Page 3 - Getting Started... The digiprint has an ON/OFF switch which should be used to control the power. Report Name Menu Access Description Should you leave the unit ON it will go into a sleep mode however the battery Driver Card Analysis...
- Page 4 Avoid pulling on the paper as this will pull the paper roll out of alignment. Make sure that your digifobpro has printing functionality enabled, see “Enabling printing within your digifobpro” on page 2. You cannot use the digiprint whilst it is charging. digiprint User Instructions Page - 6 Digiprint User Instructions...
- Page 5 Albion House 48 Albert Road North Reigate, Surrey, RH2 9EL United Kingdom Phone: +44 (0) 208 687 3900 Fax: +44 (0) 208 687 3919 E-mail: info@tachosys.com Copyright © Prosys Development Services 2009...