Reebok RBE0995.1 User Manual page 5

2. Orient the Rear Stabilizer (2) as shown. Attach the
Rear Stabilizer to the Frame (1) with four M8 x 65mm
Button Screws (95) and four M8 Split Washers (85).
3. Slide an M8 x 25mm Washer (119) onto an M8 x
20mm Button Screw (118). Tighten the Button Screw
into one end of the Incline Axle (68). Apply a small
amount of the included grease to the Incline Axle.
Orient the Ramp (5) so the opening is in the position
shown. Fit the welded tube on the underside of the
Ramp between the two rings on the top of the Frame
(1). Insert the Incline Axle (68) through the rings and
the welded tube.
Slide an M8 x 25mm Washer (119) onto an M8 x
20mm Button Screw (118). Tighten the Button Screw
into the open end of the Incline Axle (68).
4. Using your fingers, turn the shaft on top of the Motor
(46) counterclockwise until it stops turning. Next, fit the
opening of the Ramp (5) over the front of the Frame
(1) as shown. Position the U-bracket on the underside
of the Ramp over the end of the shaft as shown.
Insert the Clevis Pin (112) through one side of the U-
bracket on the Ramp (5), an 8mm Plastic Spacer
(111), the shaft on the Motor (46), another 8mm Plastic
Spacer, and the other side of the U-bracket. Then,
insert the straight end of a Hairpin Cotter Pin (65)
through the hole in the Clevis Pin.
2
1
3
5
119
118
4
5
112
5
2
85
85
95
95
Opening
Welded
Tube
119 118
Grease
1
68
1
111
65
46