Advertisement
AGM731F-AGM732F IG 17Oct11.fm Page 2 Monday, October 17, 2011 11:54 AM
Regulatory Compliance
Certificate of Manufacture/Importer
It is hereby certified the NETGEAR model AGM731F and AGM732F has been
suppressed in accordance with the condition set out in MBPT-Amtsb|Vfg 243/1991
and vfg 46/1992. The operation of some equipment (for example, test transmitters)
in accordance with regulation may, however, be subject to certain restrictions.
Please refer to the note in the operating instructions. Federal Office for
Telecommunications Approvals has been notified of the placing of this equipment on
the market and has been granted the right to test the series for compliance with
regulation.
Note:
This device has been tested and found to comply with limits for a Class B
digital device, pursuant to part 15 of FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a commercial
installation.
EN 55 024 Declaration of Conformance
This is to certify that the NETGEAR Model AGM731F/AGM732F is shielded against
the generation of radio interference in accordance with the application of Council
Directive 89/336/EEC, Article 4a. Conformity is declared by the application of EN55
024 Class A (CISPR 22).
FCC Compliance Notice: Radio Frequency Interference
This device complies with part 15 of the FCC rules.
Operation is subject to the following conditions:
•
This device may not cause harmful interference.
•
This device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause
harmful interference, in which case users will be required to take whatever
measures may be necessary to correct the interference at their own expense.
FCC Caution
•
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
•
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
•
For product available in the USA market, only channel 1~11 can be operated. Selection
of other channels is not possible.
•
This device and its antenna(s) must not be co-located or operation in conjunction with
any other antenna or transmitter.
Class 1 laser product.
Class 1 LED product.
Because invisible laser radiation may be emitted
from the aperture of the port when no fiber cable is
connected, avoid exposure to laser radiation and do
not stare into open apertures.
September 2011
Technical Support
Thank you for selecting NETGEAR products.
After installing your device, locate the serial number on the label of your product,
and use it to register your product at
http://www.NETGEAR.com/register
is required to use the NETGEAR telephone support service. For product updates,
additional documentation, and support go to
http://support.netgear.com.
For complete DoC go to the NETGEAR EU Declarations of Conformity website at
http://support.netgear.com/app/answers/detail/a_id/11621.
For GNU General Public License (GPL) related information, go to
http://support.netgear.com/app/answers/detail/a_id/2649.
WARNING!!
Do not stack equipment, or place equipment in tight spaces, or in
drawers. Be sure your equipment is surrounded by at least 2 inches
of air space.
This symbol was placed in accordance with the European Union Directive 2002/96 on the Waste
Electrical and Electronic Equipment (the WEEE Directive). If disposed of within the European Union,
this product should be treated and recycled in accordance with the laws of your jurisdiction
implementing the WEEE Directive.
NETGEAR, the NETGEAR logo, and Connect with Innovation are trademarks and/or registered trademarks of
NETGEAR, Inc. and/or its subsidiaries in the United States and/or other countries. Information is subject to
change without notice. Other brand and product names are registered trademarks or trademarks of their
respective holders. © 2011 NETGEAR, Inc. All rights reserved.
.
Registration
Advertisement
