Advertisement
Air Compressor
RABD255/50/2.5
RABD255/100/2.5
RABD265/50/3
RABD265/100/3
General instruction for installation use and maintenance
Protect yourself and others by observing all safety information, warnings, and
cautions. Failure to comply with instructions could result in personal injury
and/or damage to product or property.
Please retain instructions for future reference.
2010-11-02
Advertisement
Table of Contents
Related Manuals for Ross RABD255/50/2.5
Summary of Contents for Ross RABD255/50/2.5
-
Page 1: Air Compressor
Air Compressor RABD255/50/2.5 RABD255/100/2.5 RABD265/50/3 RABD265/100/3 General instruction for installation use and maintenance Protect yourself and others by observing all safety information, warnings, and cautions. Failure to comply with instructions could result in personal injury and/or damage to product or property. -
Page 2: Warranty
This guarantee does not cover defects caused by or resulting from: misuse, abuse or neglect; trade, professional or hire use; repairs attempted by any- one other than our authorised service agent; or damage caused by foreign objects, substances or accident. SPECIFICATIONS ITEM DATA RABD255/50/2.5 RABD255/100/2.5 RABD265/50/3 RABD265/100/3 Model 2.5hp Power... -
Page 3: General Safety Instructions
Air Compressor GENERAL SAFETY INSTRUCTIONS Before attempting to operate this compressor the following basic safety precautions should always be taken to reduce the risk of fire and personal injury. It is important to read the in- struction manual to understand the application, limitations and potential hazards associated with any tool. - Page 4 Air Compressor Do Not Over-reach Do not over-reach, keep proper footing and maintain your balance at all times. Maintain Tools with Care Keep cutting tools sharp and clean for better and safer performance. Follow the instructions for lubricating and changing accessories. Check the tool power cord periodically and if damaged have it replaced by an authorised service facility.
- Page 5 Air Compressor Disconnect Compressor Ensure that the compressor is disconnected from the mains supply and the tank is empty when not in use, before servicing, lubricating or making adjustments to air lines when changing acces- sories such as blades, bits, nails and cutters on air tools . Avoid Unintentional Starting Ensure that the switch is in the OFF position before plugging the compressor into the mains supply...
-
Page 6: General View And Main Components
Air Compressor GENERAL VIEW AND MAIN COMPONENTS Compressor pump Safety valve Pressure switch Motor Reset (ON/OFF) Regulator & outlet valves Air Filters Non return valve Drain cock Air tank Note: Fittings and location may differ from those shown above. - Page 7 Air Compressor Assembly This air compressor requires some minor assemble before it can be used. Locate the accessory pack/s. These should contain : Wheel/s and axle set. Rubber stoppers or caster wheel (100L) Position the unit on a even surface. Using the hardware provided:- ...
-
Page 8: Initial Start-Up
Air Compressor INITIAL STARTUP Ensure the unit is stable in a well-ventilated dry position. Ensure that drain the valve is closed and air outlets are closed. Check the red knob, make sure that it is in the off position ... -
Page 9: Operation
Air Compressor Operation The pressure in the tank is controlled by the action of the pressure switch located under the pressure switch cover When the set maximum pressure is reached the pressure switch activates and the motor is turned off. The pressure will then decreases as the air is used until the set minimum is reached after which the pressure switch turns the motor to on again. -
Page 10: Maintenance
Air Compressor MAINTENANCE Warning: Before maintenance operation, stop the air compressor, disconnect the unit from the mains supply and discharge all air in the air tank. Daily 1. Check oil levels before each use. 2. Drain the condensation from the air receiver. 3. -
Page 11: Troubles And Remedies
Air Compressor TROUBLES AND REMEDIES Trouble Possible causes Remedies 1 Fault in line, or voltage insufficient 1 Check the line Motor unable to 2Power wire too thin or too long 2 Replace the wire run or running 3 Fault in pressure switch 3 Repair or replace slow 4 Fault in motor... - Page 12 Air Compressor...
Need help?
Do you have a question about the RABD255/50/2.5 and is the answer not in the manual?
Questions and answers