Himoto hummer E18HM Instruction Manual page 5

MT-201T &MT-201RE Bind
Step 1: Power off both transmitter
and receiver.
MT-201T
ON
OFF
MT-201RE
CH1(Steering)Trim
CH1(Steering Dual-Rate)D/R
CH1(Steering)Reverse
MT-201T LED Display
MT-201RE LED Display
Step 2: Turn on receiver.
The LED indicator on the receiver will
begin to flash.
If the wheels point to the left or the
car wonders left while at neutral
position adjust to the right (CW)
Use this adjustment for when the
steering is reversed.
Working
Station
Indicator
Working
Station
Indicator
Step 3: Turn on the transmitter.
The transmitter and receiver will now bind
automitically within the next 2 seconds.
MT-201RE
Once the receiver LED stays lit the binding is complete.
If your car tracks straight and wheels
appear straight, do not adjust.
For less steering adjust to the left
LED ON: Power on
LED Rapid Flash: Steering wheel and/or the throttle trigger are
not in the netutral position, turn off the remote
make sure they are neutral and turn on again
LED Slow Flash: Low-voltage warning
LED OFF: Power off
LED ON: Connected
LED Rapid Flash: The singal is interrupted
LED Slow Flash: Low-voltage warning
LED OFF: Power off
04
MT-201T
ON
OFF
If the wheels point to the right or the
car wonders right while at neutral
position adjust to the left (CCW)
For more steering adjust to the right