Sony ICF-CD863V Operating Instructions

3-238-974-21(1)
TV/WEATHER/FM/AM
CD Clock Radio
Operating Instructions
Dream Machine is a trademark of Sony Corporation.
ICF-CD863V
Sony Corporation  2002
Printed in China
Owner's Record
The model number and the serial number are located on the bottom.
Record the serial number in the space provided below. Refer to them whenever you
call upon your Sony dealer regarding this product.
Model No. ICF-CD863V
Serial No.
For customers in the USA
Please register this product on line at
http:/ /www.sony.com/productregistration.
Proper registration will enable us to send you periodic mailings about new
products, services, and other important announcements.
Registering your product will also allow us to contact you in the unlikely event
that the product needs adjustment or modification. Thank you.
WARNING
Precautions
To prevent fire or shock • Operate the unit on the power source specified
in the "Specifications."
hazard, do not expose the
• The nameplate indicating operating voltage,
unit to rain or moisture. etc. is located on the bottom of the unit.
• To disconnect the power cord (mains lead),
pull it out by the plug, not the cord.
• Do not leave the unit in a location near a heat
source such as a radiator or airduct, or in a
place subject to direct sunlight, excessive dust,
mechanical vibration, or shock.
• Allow adequate air circulation to prevent
internal heat build-up. Do not place the unit on a
surface (a rug, a blanket, etc.) or near materials (a
curtain) which might block the ventilation holes.
• Should any solid object or liquid fall into the unit,
unplug the unit and have it checked by a qualified
personnel before operating it any further.
• When the casing becomes soiled, clean it with a
This symbol is intended to alert the user
soft cloth dampened with mild detergent
to the presence of uninsulated
solution. Never use abrasive cleansers or
"dangerous voltage" within the
chemical solvents, as they may mar the casing.
product's enclosure that may be of
If you have any questions or problems
sufficient magnitude to constitute a risk
concerning your unit, please consult your
of electric shock to persons.
nearest Sony dealer.
This symbol is intended to alert the user
to the presence of important operating
Troubleshooting
and maintenance (servicing)
instructions in the literature
Should any problem occur with the unit, make
accompanying the appliance.
the following checks to determine whether or not
∗ The graphical symbols are at the rear of the unit. servicing is required. If the problem persists,
consult the nearest Sony dealer.
INFORMATION
The clock does not show the correct time.
This equipment has been tested and found to
• Has an electrical power outage lasting more
comply with the limits for a Class B digital
than one minute occurred?
device, pursuant to Part 15 of the FCC Rules.
The CD, radio or buzzer alarm does not sound
These limits are designed to provide reasonable
at the preset alarm time.
protection against harmful interference in a
• Hasn't all ALARM indicator lights gone out?
residential installation. This equipment
The CD player does not operate.
generates, uses, and can radiate radio frequency
• Did you close the CD lid?
energy and, if not installed and used in
• Did you place the disc correctly?
accordance with the instructions, may cause
The disc should be placed with the labeled side up.
harmful interference to radio communications.
• Dusty or defective disc—Clean the disc with an
However, there is no guarantee that interference
optional cleaning cloth. Wipe the disc from the
will not occur in a particular installation. If this
center out.
equipment does cause harmful interference to
• Take out the CD and leave the CD
radio or television reception, which can be
compartment open for about an hour to get rid
determined by turning the equipment off and on,
of moisture condensation.
the user is encouraged to try to correct the
Sporadic loss of sound in CD operation.
interference by one or more of the following
• Dusty or defective disc—Clean or replace the disc.
measures:
• Volume too high—Reduce the volume.
— Reorient or relocate the receiving antenna.
• Strong vibration.
— Increase the separation between the
equipment and receiver. No sound comes from the speakers.
— Connect the equipment into an outlet on a • Hasn't headphones (not supplied) been plugged
circuit different from that to which the in? Disconnect the headphones from the i jack.
receiver is connected.
The display is dim.
— Consult the dealer or an experienced radio/
• The auto brightness sensor may be covered or
TV technician for help.
shadowed by something. Adjust the backlight
brightness manually.
If you have any questions about the product, you
may call:
Sony Direct Response Center 1-(800)-222-7669 or

Specifications

write to:
Sony Direct Response Center 12451 Gateway
AUDIO POWER SPECIFICATIONS
Blvd. Fort Myers, FL 33913
POWER OUTPUT AND TOTAL HARMONIC
Declaration of Conformity
DISTORTION
Trade Name: SONY
With 3.2–ohm loads, both channels driven from
Model: ICF-CD863V
150 – 10 000 Hz; rated 0.8 W per channel-
Responsible Party: Sony Electronics Inc.
minimum RMS power, with no more than 10 %
Address: 680 Kinderkamack Road,
total harmonic distortion in AC operation.
Oradell, NJ 07649 USA
Woofer with 3.2–ohm loads, driven at 50 – 150
Telephone Number: 201-930-6972
Hz; rated 3.2 W minimum RMS power, with no
more 10 % total harmonic distortion in AC
This device complies with Part 15 of the FCC
operation.
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
CD player section
harmful interference, and (2) this device must
System: Compact disc digital audio system
accept any interference received, including
Laser diode properties: Material: GaAlAs
interference that may cause undesired
Wavelength: 780 nm
operation.
Emission duration: Continuous
Laser output: Less than 44.6 µW
You are cautioned that any changes or
(This output is the value measured at a
modifications not expressly approved in this
distance of about 200 mm from the objective
manual could void your authority to operate
lens surface on the optical pick-up block with
this equipment.
7 mm aperture.)
Frequency response: 20-20 000 Hz
CAUTION
Wow and flutter: Below measurable limit
The use of optical instruments with this
product will increase eye hazard.
Radio section
Frequency range:
TV:
Before You Begin
WEATHER: 1 – 7 ch
FM:
Thank you for choosing the Sony CD clock radio!
AM:
It will give you many hours of reliable service
and listening pleasure. General
Before operating the unit, please read these
Time display: 12-hour system
instructions thoroughly and retain them for
Speaker:
future reference.
Front speaker: 77 mm (3

Features

Woofer: 80 mm (3
Outputs: i (headphones) jack (ø 3.5 mm stereo
• TV/WEATHER/FM/AM 4 band PLL (phase
locked loop) synthesized clock radio
Power outputs:
• Easy preset digital tuning with 25 memory
Front speaker: 1.5W + 1.5W (at 10% harmonic
presets
• Built-in CD player with CD-R/RW playback
Woofer: 3.5 W
function
Power requirements: 120 V AC, 60 Hz
• High Quality 3D Sound with powerful MEGA
BASS sound system Dimensions:
Approx. 185 × 195 × 196 mm (w/h/d)
• Triple Alarm (Radio, buzzer or CD) with the
extendable snooze function.
(Approx. 7
• Gentle Wake/Sleep Function
projecting parts and controls
• Easy nap timer –one push operating.
Mass: Approx. 2 700 g (5 lb 15 oz)
• LCD with backlight which has a auto
brightness control
Design and specifications are subject to change
• D.S.T. (Daylight Saving Time) –Summer time
without notice.
calculation.
IMPORTANT SAFEGUARDS
For your protection, please read these safety instructions completely before operating the appliance,
and keep this manual for future reference.
Carefully observe all warnings, precautions and instructions on the appliance and in the operating
instructions, and adhere to them.
INSTALLATION
Water and Moisture
Do not use powerline operated appliances near water - for example, near a bathtub, washbowl,
kitchen sink, or laundry tub, in a wet basement, or near a swimming pool, etc.
Heat
Do not place the appliance near or over a radiator or heat register, or where it is exposed to direct
sunlight.
Ventilation
The slots and openings in the cabinet are provided for necessary ventilation. To ensure reliable
operation of the appliance, and to protect it from overheating, these slots and openings must never be
blocked or covered.
-Never cover the slots and openings with a cloth or other materials.
-Never block the slots and openings by placing the appliance on a bed, sofa, rug or other similar
surface.
-Never place the appliance in a confined space, such as a bookcase, or built-in cabinet, unless proper
ventilation is provided.
Accessories
Do not place the appliance on an unstable cart, stand, tripod, bracket, or table. The appliance may fall,
causing serious injury to a child or an adult, and serious damage to the appliance. Use only a cart,
stand, tripod, bracket, or table recommended by Sony.
-An appliance and cart combination should be moved with care. Quick stops, excessive force, and
uneven surfaces may cause the appliance and cart combination to overturn.
Wall or Ceiling Mounting
If your appliance can be mounted to a wall or ceiling, mount it only as recommended by Sony.
USE
Power Source
This appliance should be operated only from the type of power source indicated on the marking label.
If you are not sure of the type of electrical power supplied to your home, consult your dealer or local
power company. For those appliances designed to operate from battery power, or other sources, refer
to the operating instructions.
Grounding or Polarization
This appliance is equipped with a polarized AC power cord plug (a plug having one blade wider than
the other), or with a three-wire grounding type plug (a plug having a third pin for grounding). Follow
the instructions below:
-For the appliance with a polarized AC power cord plug:
This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to
insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact
your electrician to have a suitable outlet installed. Do not defeat the safety purpose of the polarized
plug by forcing it in.
-For the appliance with a three-wire grounding type AC plug:
This plug will only fit into a grounding-type power outlet. This is a safety feature. If you are unable to
insert the plug into the outlet, contact your electrician to have a suitable outlet installed. Do not defeat
the safety purpose of the grounding plug.
Overloading
Do not overload wall outlets, extension cords or convenience receptacles beyond their capacity, since
this can result in fire or electric shock.
When not in use
Unplug the power cord of the appliance from the outlet when left unused for a long period of time.
To disconnect the cord, pull it out by grasping the plug. Never pull the plug out by the cord.
Power-Cord Protection
Route the power cord so that it is not likely to be walked on or pinched by items placed upon or
against them, paying particular attention to the plugs, receptacles, and the point where the cord exits
from the appliance.
Lightning
For added protection for this appliance during a lightning storm, or when it is left unattended and
unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable
system. This will prevent damage to the appliance due to lightning and powerline surges.
Object and Liquid Entry
Never push objects of any kind into the appliance through openings as they may touch dangerous
voltage points or short out parts that could result in a fire or electric shock. Never spill liquid of any
kind on the appliance.
Cleaning
Unplug the appliance from the wall outlet before cleaning or polishing it. Do not use liquid cleaners
or aerosol cleaners. Use a cloth lightly dampened with water for cleaning the exterior of the appliance.
Clean the appliance only as recommended by Sony.
Attachments
Do not use attachments not recommended by Sony, as they may cause hazards.
ANTENNAS
Outdoor Antenna Grounding
If an outdoor antenna or cable system is installed, follow the precautions below.
An outdoor antenna system should not be located in the vicinity of overhead power lines or other
electric light or power circuits, or where it can come in contact with such power lines or circuits.
WHEN INSTALLING AN OUTDOOR ANTENNA SYSTEM, EXTREME CARE SHOULD BE TAKEN
TO KEEP FROM CONTACTING SUCH POWER LINES OR CIRCUITS AS CONTACT WITH THEM
IS ALMOST INVARIABLY FATAL.
Be sure the antenna system is grounded so as to provide some protection against voltage surges and
built-up static charges. Section 810 of the National Electrical Code provides information with respect
to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an
antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection
to grounding electrodes, and requirements for the grounding electrode.
Antenna Grounding According to the National
Electrical Code
+1
dB
–1.5
2 – 13 ch
NEC-NATIONAL
ELECTRICAL CODE
87.5 – 108 MHz
SERVICE
530 – 1 710 kHz
Damage Requiring Service
Unplug the appliance from the wall outlet and refer servicing to qualified service personnel under the
following conditions:
-When the power cord or plug is damage or frayed.
-If liquid has been spilled or objects have fallen into the appliance.
inches) dia. ×2,
1 /
8
-If the appliance has been exposed to rain or water.
3.2 Ω
-The appliance does not appear to operate normally or exhibits a marked change in performance.
inches) dia., 3.2 Ω
1 /
-This indicates a need for service.
4
-If the appliance does not operate normally when following the operating instructions, adjust only
those controls that are specified in the operating instructions. Improper adjustment of other controls
minijack)
may result in damage and will often require extensive work
by a qualified technician to restore the appliance to normal operation.
-If the appliance has been subject to excessive shock by being dropped, or the cabinet has been
distortion) damaged.
Servicing
Do not attempt to service the appliance yourself as opening or removing covers may expose you to
dangerous voltage or other hazards.
Refer all servicing to qualified service personnel.
Replacement parts
× 7 × 7
3 3 3
/ / / inches) incl.
8 4 4
When replacement parts are required, be sure the service technician has used replacement parts
specified by Sony that have the same characteristics as the original parts.
Unauthorized substitutions may result in fire, electric shock, or other hazards.
Safety Check
Upon completion of any service or repairs to the appliance, ask the service technician to perform
routine safety checks (as specified by Sony) to determine that the appliance is in safe operating
condition.
Antenna Lead-in Wire
Ground
Antenna Discharge Unit
Clamps
(NEC Section 810-20)
Grounding Conductors
Electric Service
(NEC Section 810-20)
Equipment
Ground Clamps
Power Service Grounding Electrode System
(NEC Art 250 Part H)