Moving And Storage - GE GFW148 Owner's Manual And Installation Instructions

Care and cleaning
Dispenser Drawer Area
Detergent and fabric softener may build up in the dispenser drawer.
Residue should be removed once or twice a month.
• Remove the drawer by first pulling it out until it stops. Then reach back into the
rear center of the drawer cavity and press down firmly on the lock tab, pulling
out the drawer.
• Remove all cups and inserts from the dispenser drawer. Rinse the inserts, cups
and drawer with hot water to remove traces of accumulated laundry products.
• To clean the drawer opening, use a small brush to clean the recess.
Remove all residue from the upper and lower parts of the recess.
• Return inserts to the proper compartments. Replace the dispenser drawer.
• To reduce buildup in the Dispenser Drawer area:
Use only HE
High-Efficiency
detergent.

Moving and Storage

Ask the service technician to remove water from drain pump and hoses. Do not store the washer where it will be
exposed to the weather. When moving the washer, the tub should be kept stationary by using the shipping bolts
removed during installation. See Installation Instructions in this manual. If these parts are not available, they can be
ordered by visiting our Website at GEAppliances.com or by calling GE Appliances at 800.GE.CARES.
Long Vacations
Be sure water supply is shut off at faucets. Drain all water from hoses and water filter pump area if weather will be
below freezing.
49-90570-1
Lock tab is visible
only after drawer has
been pulled out
Lock
Tab
13