Ipad Control - Ashly digiMIX24 Operating Manual

Operating Manual - digiMIX24 Digital Mixer
 9 iPAD REMOTE CONTROL
A free remote control iPad app called "Ashly digiMIX24" is available from the iTunes
App Store. Most mixer touchscreen controls are duplicated on the app for wireless
remote control of the mixer, including EZ-Mode. Note: The digiMIX24 does not
provide its own Wi-Fi signal, so an existing network with Wi-Fi must be available
for the iPad. Only one iPad at a time can be used to control the digiMIX24.
IMPORTANT: digiMIX24 for iPad Ver. 5.0 or later can only be
used with a digiMIX24 mixer running firmware update V5.0 or
later. See sec. 6.1 for firmware update details.
9.1 iPad Setup steps
9.1a - Configure the iPad Wi-Fi to be on the same network subnet as the mixer
9.1b - Download, install and launch the Ashly digiMIX24 app with the mixer
turned on and connected to the network.
9.1c - On startup, the digiMIX24 app displays a device list of IP
addresses(mixer names) for any mixer(s) on the network. Select
an IP address and press <Connect>.
9.1d - In the resulting mixer display, a green box in the upper left
corner indicates that the app is connected to a live mixer. It turns
grey if the connection is lost. If it is grey, press the box to return
to the Device List used in step 9.1c. When connected, the iPad
always displays the same screen as the mixer. Changes to either
device will result in an identical change to the other device. The
fader on the left side of this screen always controls the currently
selected channel, or channel pair if two channels are stereo linked.
9.1e - To access the Assign, Channel, PEQ, Expander/Gate, or
Compressor/Limiter control screens for the currently selected
channel, press the "PEQ BOX" as shown in the upper left corner
of the mixer screen in the illustration to the right.
► TIP: If two channels are stereo linked, tapping the fader on
the left side of this screen alternately toggles between the two
linked channels, offering the ability to select and pan either
channel separately from within the Assign or Channel screens.
9.1f - To backup/restore presets, access EZ Mode or other system
functions from the iPad app control surface, press the <System> but-
ton while in any of the control screens mentioned above in step 9.1e.
9.2 iPad EZ Mode
EZ Mode offers two different configurations for simplified remote
control of the mixer's DCA groups, Aux master outputs, Subgroup
outputs, USB or Tape input levels, or Main output level. The two
EZ Mode mixers on the iPad app are the same as on the digiMIX24.
See section 6.4 for complete EZ Mode details. To use EZ Mode
on the iPad, go to the system page as described above in step 9.1f
and press the EZ Mode button.
9.3 iPad EZ-Mode Password Protection
EZ-Mode will always use the same four-character password as
the mixer (sec. 5.5). The password must initially be entered on
the mixer, then can be used on the iPad to lock EZ-Mode faders
or fader icons. Passwords are case sensitive.
28
9.1c) digiMIX24 app IP address selection
9.1d & 9.1e) digiMIX24 app Mixer Mode Display
9.2: digiMIX24 app EZ-Mode