Table of Contents
Advertisement
Using the TV/VCR's Features
8 : 40AM THU
00 : 30 : 00
Hours Minutes Seconds
8 : 47AM MON
00 : 04 : 38 SP
26
Time Counter
CH 012
The time counter shows the actual time used in recording or playing back a
tape. The time counter helps locate the beginning or end of recorded events. It
resets to 00:00:00 whenever a tape is ejected from the TV/VCR.
For example, if you record a 30-minute program at the beginning of a tape,
SP
rewind it, and then want to go to the end of the first program to start another
recording:
1. Press the CALL button to display the time counter.
2. Press the RESET button to reset the time counter to 00:00:00.
3. Press FORWARD to advance a tape until the time counter reads 00:30:00.
4. Press STOP. This is the approximate end of a 30-minute program (you may
want to press PLAY to verify). When the tape is cued correctly, you can
begin recording.
5. Press the CALL button to remove the time counter from the screen and
return to the normal display mode.
Channel Banner
CH 012
There are several indicators that might appear when you press the CALL button.
This display is called the Channel Banner. The following list describes the items
on the Channel Banner screen (left to right and top to bottom).
8:47 AM
MON
CH 012
00:04:38
SP
Displayed when a tape is playing. This symbol changes
depending what playback mode you are in. (See Playback
Mode symbols on next page).
Displays the current time.
Displays the current day.
Displays the current channel or input channel.
Displayed when Auto Repeat has been set.
Displayed when a cassette is loaded in the VCR.
Displays the amount of time the tape has played.
Displays the tape speed.
Chapter 2
Advertisement
Table of Contents
