Table of Contents
Advertisement
Connecting External Speakers with 3-Way Operation
1. Plug in the external speaker .
Depress the black tab and insert the black speaker wire into the speaker
jack. Depress the red tab and insert the red (or other color) speaker wire
into the speaker jack.
2. Set the speaker switch to the desired selection:
INT
Listen to the TV/VCR's audio only through the internal
speaker.
BOTH Listen to the audio through both the internal speaker and an
external speaker connected to the external speaker jacks.
EXT
Listen to the audio only through the external speaker
connected to the external speaker jacks.
Caution: If the switch is in the EXT position and no external speaker is
connected, you will not be able to hear the TV/VCR's audio.
Note: The external speaker must be a minimum of 8 ohms. Connecting
a speaker of less than 8 ohms could damage the TV/VCR.
Replacing the Fuse in the DC Car Cord
1. Unscrew the end of the plug by turning it counterclockwise. When
you remove the end, you will see the fuse.
2. Replace the fuse with a new 250-volt, 10-amp fuse (available from
your local dealer).
3. Screw end (with new fuse attached) back on plug.
Cleaning the TV/VCR
Turn off the TV/VCR before cleaning.
You can clean the TV/VCR as required by using a soft cloth or the dusting
attachment of your vacuum cleaner. Be sure to occasionally vaccuum the
ventilation slots in the cabinet to help assure adequate ventilation.
To clean the TV/VCR screen, use a soft cloth dampened with a diluted soap
and water mixture. Do not use furniture polish on the TV/VCR cabinet or screen.
While cleaning, do not spray liquid directly on the screen or allow liquid to
run down the screen or inside the TV/VCR. Also, avoid placing drinks or
vases with water on top of the TV/VCR. This could increase the risk of fire,
shock hazard, or damage to the TV/VCR.
—
+
INPUT
BOTH
INT.
EXT.
AUDIO
VIDEO
References
IN FROM
ANTENNA
33
Advertisement
Table of Contents
