NETGEAR XAVNB2001 Installation Manual page 16

3. Within two (2) minutes, press and hold
the XAVN2001 On/Off button for
7+ seconds until the wireless LED
starts blinking.
This activates the auto configuration on
the XAVN2001. The LED stops flashing
when setup is successful.
4. Move the XAVN2001 to the area (or
dead zone), where you want to extend
the wireless coverage.
5. Plug the Powerline AV 200 Adapter (XAV2101) into a wall outlet
near your router, and use an Ethernet cable to connect it to the
LAN port on the router. See Room 1 illustration.
6. Ensure that both the XAV2101 and XAVN2001 are connected by
checking the Powerline LEDs. If the LEDs are green or amber,
the devices are successfully connected. A red LED indicates a
weak link rate of 50 Mbps or less. In this case, move the adapter
to another plug with a better connection.
Wireless devices in that "dead" area can now connect to your
network through the Powerline Adapter and Wireless Extender.
about
On/Off
16