NETGEAR XAVNB2001 Installation Manual page 15

8. When you are finished using the Powerline Utility, disconnect the
Ethernet cable from the Powerline Extender (XAVN2001), and
move the Powerline Extender to the area (or dead zone), where
you want to extend wireless coverage, and plug it into an
electrical outlet.
Method B: Using the WPS Button
Use this method if you have a wireless router, or modem router with a
WPS (Wi-Fi Protected Setup™) Push 'N' Connect button:
1. Plug the XAVN2001 into a wall outlet
close to your
within the router's wireless coverage
area.
2. Press the WPS button on the router.
Note: The WPS button may be labeled
WPS, or may look similar to
router to ensure that it is
or .
15
WPS