General Error Function - Samsung P8091GW1/YLP Service Manual

4. General Error Function

•
When an error occurs, this function starts to keep generating error melody sounds and displays error indicators
as shown in the followings per corresponding error by blinking in 0.5sec intervals until the error status is completely
cleared out. In this case, all the driving devices are turned off until the error is cleared out.
1. WATER SUPPLY ERROR
- Water Supply Error occurs when water level frequency does not show changes more than 50Hz or water is not supplied up
to the water level presetting for 20 min or more at the time of initial water supply, the error status can be cleared by turning
POWER S/W OFF and resuming the POWER ON initial status.
- Display shows 'E1'.
2. WATER DRAIN ERROR
- Display shows ëE2í .
- In case the water level frequency is 25.5KHz or less in the initial phase of UNB-detecting cycle.
- Water Drain error can be cleared by turning POWER S/W OFF and resuming the POWER ON initial status.
3. OVER-FLOW ERROR
- Display shows ëE3í .
- Over-Flow error occurs when the water level is in abnormal operation. It can be cleared by turning POWER S/W OFF.
Water is drained prior to POWER S/W OFF and it is forced to be drained for 2 min if a frequency of more than 25.24
KHz is detected.
4. DOOR OPEN ERROR
- Display shows ëdEí
- Door Open error can be cleared by closing the door.
5. UNBALANCE ERROR
- Display shows ëE4í .
- Unbalance error is cleared by POWER S/W OFF and by resuming the POWER ON initial status.
6. WATER HEATER ERROR
- Display shows ëE5,E6í .
- In case the water temperature rises by 40 ° C or more in 5 min. or by 2 ° C less in 10 min after heating is started.
- It can be cleared by turning POWER S/W OFF.
7. ASSí Y PRESSURE S/W ERROR
* Generated Frequency Signal of WATER LEVEL(W/L) S/W (KHz)
Level
Abnormal W/L Frequency
- If the same signal as the above table is detected for more than 5 seconds, it is a PRESSURE S/W Error.
- When the error occurs, water drain pump will operate for 3 min. and then turn off the water drain pump.
Then the display shows ëE7í indicating a pressure s/w error indicator.
8. ABNORMAL WATER TEMPERATURE ERROR
Course
Synthetic
Delicate
Wool
- In case the water temperature is 60 ° C or more in the synthetic course, 50 ° C or more in the delicate
- At the time of initial water supply, if the water temperature is not appropriate, water starts to be drained
and it is forced to be drained for 2 min when the abnormal frequency of 25.24KHz is detected.
- Display shows ëE8í .
- This error can be cleared by POWER S/W OFF.
Low Level High Level
30.00 KHz 15.00 KHz
Water Temp
°
60 C or more
°
45 C or more
°
45 C or more
5