Craftsman 580.752410 Operator's Manual page 4

7.0 horsepower 2900 psi 2.3 gpm
Hide thumbs Also See for 580.752410:
Table of Contents

Advertisement

Available languages

Available languages

WARNING
Rapid retraction of starter cord (kickback)
will pull hand and arm toward engine faster
than you can let go.
Broken bones, fractures, bruises or sprains
could result.
• ALWAYS point gun in safe direction and squeeze spray
gun trigger, to release pressure and avoid kickback each
time, before starting engine. Engage trigger lock when
not in use.
• When starting engine, pull cord slowly until resistance is
felt and then pull rapidly to avoid kickback.
• After each starting attempt, where engine fails to run,
always point gun in a safe direction and squeeze spray
gun trigger to release high pressure.
WARNING
Use of pressure washer can create puddles
and slippery surfaces.
High pressure spray could cause you to fall
if you are too close to the cleaning surface.
• Keep spray nozzle between 8 to 24 inches away from
cleaning surface.
• Operate this unit on a stable surface.
• Cleaning area should have adequate slopes and drainage
to reduce possibility of falls due to slippery surfaces.
• Be extremely careful if you must use pressure washer from a
ladder, scaffolding or any other relatively unstable location.
• Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury if gun kicks back.
WARNING
Spray contact with electrical wiring can
result in electrocution.
• Keep water spray away from electric wiring or fatal
electric shock may result.
WARNING
Running engines produce heat.
Temperature of muffler and nearby areas
can reach or exceed 150°F (65°C).
Severe burns can occur on contact.
Exhaust heat/gases can ignite combustibles,
structures or damage fuel tank causing a fire.
• DO NOT touch hot surfaces and avoid hot exhaust gases.
• Allow equipment to cool before touching.
• Keep at least 5 ft. (152 cm) clearance on all sides of
pressure washer including overhead.
• Code of Federal Regulation (CFR) Title 36 Parks,
Forests, and Public Property require equipment powered
by an internal combustion engine to have a spark
arrester, maintained in effective working order, complying
to USDA Forest service standard 5100-1C or later
revision. In the State of California a spark arrester is
required under section 4442 of the California Public
resources code. Other states may have similar laws.
WARNING
The high pressure stream of water that this
equipment produces can pierce skin and its
underlying tissues, leading to serious injury
and possible amputation.
Spray gun traps high water pressure, even
when engine is stopped and water is
disconnected, which can cause injury.
• NEVER aim spray gun at people, animals or plants.
• DO NOT allow CHILDREN to operate pressure washer.
• NEVER repair high pressure hose. Replace it.
• NEVER repair leaking connections with sealant of any
kind. Replace o-ring or seal.
• Keep high pressure hose connected to pump and spray
gun while system is pressurized.
• ALWAYS point gun in safe direction and squeeze spray
gun trigger, to release high pressure, every time you stop
engine. Engage trigger lock when not in use.
4

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents