Fm Antennas - RCA Stereo Receiver with Remote Control Owner's Manual

You can also use an optional RadioShack shortwave antenna kit,
which makes an excellent outdoor AM antenna. Connect the outdoor
AM antenna wire to the receiver' s

FM Antennas

Connect the supplied FM antenna to the
terminal as shown then extend it.
For better FM reception, you can also use a rabbit-ear TV antenna
(for indoor use only) or an outdoor VHF TV antenna. To connect the
TV antenna to the receiver, you need a VHF/ UHF/FM splitter (not
included). RadioShack stores carry a full line of quality antennas and
antenna connection accessories.
Warning: To prevent injury, read and follow all cautions and
warnings that accompany the outdoor antenna. Use 75-ohm coaxial
cable to connect an outdoor antenna to the receiver.
For the best radio reception, use an outdoor antenna. Follow these
steps to connect an outdoor FM antenna to the receiver using 75
coaxial cable.
Note: If your antenna has 300 twin-lead cable, connect it to the
terminals.
300 ANTENNA
1. Disconnect the supplied FM antenna from the receiver' s
terminal.
300 ANTENNA
2. With a stripping tool, remove about 1
cable' s outer insulation to expose the cable' s shielding.
AM ANTENNA terminal as shown.
FM 300 ANTENNA
FM
1
/ inches of the 75
2
3. Fold back the shielding from the inner insulation.
4. Remove about 1 inch of the inner insulation from around the
center wire.
5. Pull the shielding to one side. Connect the center wire to the
receiver' s
FM 75 ANTENNA
secure any loose wire strands, and connect it to the
terminal.
ANTENNA
Caution: The cable' s shielding should only touch the
terminal.
ANTENNA
Note: Grounding is not necessary for reception, but we recommend
it for better FM reception and to avoid damage from lightning when
you use an outdoor FM antenna. Use a separate piece of thick
polyvinyl insulated wire to connect the
an earth ground, such as a metal cold-water pipe.
Warning: Never connect a wire to a gas pipe for grounding since
sparks might ignite the gas.
FM
terminal. Twist the shielding to
GND
GND
terminal to
GND ANTENNA
7