Table of Contents
Advertisement
Getting Started
Setup
Setting up, and using your Light Viper EF‐2 is a quick and simple process. Just follow these steps:
1.
Mount one EF‐2 in a rack close to the Ethernet source.
2.
Mount the other EF‐2 in a rack close to the Ethernet destination.
3.
Connect the units to either AC power using the IEC connector or 12VDC using the green modular connector.
4.
Connect and run the Fiber between the two units, power up and check the 'link' light on both units
5.
Set the switches for the appropriate signal.
6.
Connect the data connections to the RJ‐45 jacks.
The specific functions of the Light Viper EF‐2 (direction, polarity, etc.) are addressed within this manual.
5
Advertisement
Table of Contents
