Back Panel Controls - RCA DRD403RA Owner's Manual

Reference
OUT
TO
TV
S-VIDEO
IN CH 3
FROM
CH 4
ANT

Back Panel Controls

IN FROM ANT Use to connect an off-air antenna or cable TV signal
®
to the DSS system.
OUT TO TV Use to connect the DSS
if your TV has audio/video jacks, you should use those jacks to get
better picture and sound quality.
CH3/CH4 SWITCH If a coaxial cable is used to connect the DSS
receiver to your TV, you must set the CH3/CH4 SWITCH. For
example, to see the DSS
S-VIDEO Provides the best picture quality. If your TV has S-VIDEO
capability, use this jack along with the audio/video jacks to connect
the DSS ® receiver to your TV.
VIDEO Provides better picture quality than the OUT TO TV jack. If
your TV has audio/video capability, use this jack to connect the DSS
receiver to your TV. You must also connect the AUDIO jacks.
AUDIO (R and L) Provide better sound quality than the OUT TO TV
jack. If your TV has audio/video capability, use these jacks to connect
the DSS ® receiver to your TV. You must also connect the VIDEO jack.
WIDE BAND AND LOW SPEED DATA PORTS These ports allow you
to connect the DSS ® system to future services and accessories as they
become available. A shielded cable and additional hardware may be
required.
SATELLITE IN Use to connect the DSS
PHONE JACK Use to connect a phone line to the DSS
®
DSS system requires a phone line connection to periodically call out
to program providers.
VCR CONTROL Allows the receiver and VCR to communicate with
each other.
REMOTE IN Use in conjunction with a remote control signal sender.
VIDEO R AUDIO L WIDE BAND DATA
®
receiver to your TV. However,
® signal on TV channel 3, set the switch to 3.
® receiver to the satellite dish.
VCR CONTROL
SATELLITE IN
REMOTE IN
®
®
® receiver. The
PHONE JACK
LOW SPEED DATA
51