Error Contents; Remote Controller - Fujitsu ARG36ELC3 Service Manual

1. REMOTE CONTROLLER

When EE : EE blinks at the current time display, there is an
error inside the air conditioner. If the SET TIME button (
and TEMP./DAY button (
more than three seconds, the self diagnosis check will start
and the error contents will be displayed at the current time
display. When the operation lamp lights, press the
START/STOP button and after operation lamp goes off,
perform the same operation. Process the error contents by
referring to (Table 1).
NON STOP CLOCK TEMP AUTO
HIGH
1 2
DEFROST
TIMER SET TIME TEMP./DAY FAN
MODE CONTROL
MASTER
CONTROL
CLOCK ADJUST
ZONE ENERGY SAVE START/STOP
SET DAY OFF
Stop operation.
2003.09.22
E R R O R
) are pressed simultaneously for
AUTO
COOL
1 2
TIMER SET TIME TEMP./DAY FAN
MODE CONTROL
MASTER
CONTROL
CLOCK ADJUST
ENERGY SAVE START/STOP
SET DAY OFF
C O N T E N T S
Error cord
)
Communication error
(indoor unit
Communication error
(indoor unit
Room temperature sensor open
Room temperature sensor shortcircuited
Indoor heat exchanger temperature sensor open
Indoor heat exchanger temperature sensor
shortcircuited
Outdoor heat exchanger temperature sensor
open
Outdoor heat exchanger temperature sensor
shortcircuited
Power source connection error
Float switch operated
Outdoor temperature sensor open
Outdoor temperature sensor shortcircuited
Discharge pipe temperature sensor open
Discharge pipe temperature sensor shortcircuited
Outdoor high pressure abnormal
Discharge pipe temperature abnormal
Model abnormal
Indoor fan abnormal
Outdoor signal abnormal
Outdoor EEPROM abnormal
To stop test running, press the START/STOP button.
For the operation method, refer to the operating manual and
perform operation check.
Check that there are no abnormal sounds or vibration
sounds during test running.
- 6 -
ARG36ELC3 / AOG36EPA3L
ARG45ELC3 / AOG45EPA3L
ARY36ELC3 / AOY36EPA3L
ARY45ELC3 / AOY45EPA3L
Table 1

Error contents

remote controller)
outdoor unit)