Advertisement
Green, on, the USB Slider is connected to a GPRS/EDGE network.
Blue, on, the USB Slider is connected to a WCDMA network.
Cyan, on, the USB Slider is conn
O , the USB Slider is removed.
ff
SIM/USIM Card
It is
w
here you insert the subscrib
module (SIM/USIM) card.
Micro SD Card Slot
It is where you insert the Micro Secure Digital Memory (SD)
Getting Your USB Slider Ready
1.
Remove the back cover of the USB Sli
2.
Insert the USIM/SIM card and the micro SD
that the cards are properly inserted.
3.
Install the back cover of the USB Slider.
Note:
Do not remove the Micro SD card when it is being used. Removing the card during
an operation may damage the Micro SD card as well as the dev
on the card may be corrupted.
Installation/Removal Guide
On different operating systems (OSs), the installation and remo
may differ. Follow the system prompts during operation.
Connecting the USB Slider with a Computer
Note:
Fi
rst, power on the computer. Then connect the USB Slider with the computer.
Otherwise, the USB Slider cannot be installed as normal.
1.
Plug the USB Slider into the USB
2.
The OS automatically detects and recognises n
installation wizard.
3.
Follow the prompts of the installation w
4.
After the program is installed, a shortcut icon fo
program is displayed on the desktop.
ected to a HSPA+ network.
Slot
er identity module/UMTS subscriber identity
der.
interface of the laptop or desktop computer.
izard.
card
card into the card slots. Make sure
ice, and data stored
ew hardware and starts the
r the USB Slider management
val procedures
Advertisement
