Viking DVA-2WA Product Manual page 7

A. Recording from an Electret Microphone or Carbon Handset
Set DIP switch 1 to the OFF position and remove any background music source from the AUX
Step 1.
AUDIO input.
Connect the 1/8" Electret microphone plug to the Record Audio input and set DIP switch 7 to the
Step 2. OFF position or connect a carbon handset to the modular jack of the DVA-2WA and set DIP switch
7 to the ON position. See page 9.
Slide the PLAY/RECORD switch to the right, the LED will light steady to indicate the DVA-2WA is in
Step 3.
the record mode. Note: To avoid feedback, turn the Master Volume control to "min" position.
Momentarily press the START/STOP button to begin recording. The LED will flash fast to indicate
Step 4.
you are recording.
Step 5. Momentarily press the START/STOP button again to stop recording, the LED will light steady.
Step 6. Repeat steps 4 and 5 for each message you wish to record.
Step 7. Slide the PLAY/RECORD switch to the left to place the DVA-2WA back into the play mode.
Turn up the Master Volume control and review recording(s) by momentarily pressing the
Step 8.
START/STOP button and listening to messages in handset, speakers or 600 ohm output.
Notes: If the total available record time is surpassed while recording, the status LED will pulse hi-low. To re-
record all user-recorded messages, move the switch to play then back to the record position. This will allow you
to record over all the previous messages in memory.
120V AC
1
OFF
DIP Switches
(see page 9)
Start/Stop Button
Carbon Handset
Set DIP switch 7 to ON
(Viking part # Q171030 or
equivalent, not included)
Recording
VIKING
MODEL DVA-2WA
©
MASTER
VOLUME
VIKING
ELECTRONICS
HUDSON WI, 54016
MIN MAX
MADE
DIGITAL ANNOUNCER
WITH 2 WATT AMPLIFIER
USA
ON
1 2 3 4
1 2 3
C
C
Electret Microphone with 1/8" jack
(www.nrgresearch.com) or equivalent, not included)
AUX. AUDIO
VOLUME
MIN MAX
IN
5 6 7 1 2 3 4 5 6
4 1 5 6 7
Set Dip switch 7 to OFF
(NRG Research Inc. Part # SA-125
7
DIP Switches
(see page 9)
DIP switch 7 ON
7
ON
for CarbonHandset
DIP switch 7 OFF
OFF
for Electret Mic
Important: If you experience hum during
the playback of user-recorded messages,
earth ground Speaker Output terminal 5
before recording messages.