EN
2.4. Control and display elements
The operation of the DRYPOINT
operating status will be represented by LED indicators.
3
...
Power
1
...
2
The pressure points on the >>Test<< and >>Value<< buttons are designed in such a way that inadvertent touching cannot
trigger operating functions. The software is programmed in such a way that a button must be pressed for a longer time
(approx. 0.2 second) to acquire a desired operating function.
If an operation function is initiated with a continuous pressing of the button(s), then the device will indicate the possible
commencement of the operation: All green value LEDs (3) flash. A time span of 10 seconds is then open for the action after
releasing the button(s). Every actuation of a button during this time span will result in the time span being available again
for the complete duration.
Once the action has been completed and no button has been pressed for 10 seconds, the confirmation for the action will be
executed via the control , all green value LEDs (3) flash.
The system then transfers into normal mode and will be controlled on the basis of the prescribed settings.
NOTICE
Additional information
For additional information regarding the display and the test function of the solenoid valve, refer to
"Operation" on Page 25.
DRYPOINT
M eco control
®
M eco control is executed via the user interface on the top of the housing. The current
®
∆
10
20
30
Test
+10
+5
0
°C
P
ressure
D
ew
P
oint
∆
35 45 55
Value
-5 -15 -26
°C
Power LED (green)
1
Indicator for the operating mode and voltage
power supply
Warning LED (red)
2
Indicator for alarms, errors and malfunctions in
4
operation
3
Value LED (green)
Indicator for the set point values
5
>>Test<< button
4
Setting the operating mode or for testing the
solenoid valve function
>>Value<< button
5
Setting the degree of drying or activating the
service mode
+
Press and hold the >>Test<< + >>Value<< buttons
4
5
Unlock software → acquiring settings
Installation and operating manual
13