Replacing The Processor; Procedure; Post-Requisites - Dell Inspiron 3470 Service Manual

WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your
your computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
CAUTION: If either the processor or the heat sink is replaced, use the thermal grease provided in the kit to ensure that thermal
conductivity is achieved.
NOTE: A new processor ships with a thermal pad in the package. In some cases, the processor may ship with the thermal pad
attached to it.
Topics:
•

Procedure

•

Post-requisites

Procedure
1 Ensure that the release lever on the processor socket is fully extended in the open position. Then align the notches on the processor
with the tabs on the processor socket and place the processor in the processor socket.
CAUTION: The pin-1 corner of the processor has a triangle that aligns with the triangle on the pin-1 corner on the processor
socket. When the processor is properly seated, all four corners are aligned at the same height. If one or more corners of the
processor are higher than the others, the processor is not seated properly.
CAUTION: Ensure that the processor-cover notch is positioned underneath the alignment post.
2 When the processor is fully seated in the socket, close the processor cover.
3 Pivot the release-lever down and place it under the tab on the processor cover.
Post-requisites
1 Replace the thermal-cooling
2 Replace the fan shroud.
3 Replace the memory modules.
4 Follow the procedure from step 5 to step 8 in
5 Replace the front bezel.
6 Replace the computer cover.
58

Replacing the processor

computer. After working inside your computer, follow the instructions in
assembly.
"Replacing the optical
Replacing the processor
drive".
33
After working inside
www.dell.com/