Toolmstconnectors - adt-audio TOOLMIX16 User Manual

ToolMix/ToolMst User Manual
ToolMst Connectors
The outputs of the stereo master are available on separate XLR connectors. In addition to the standard power connectors and the couple
connector, all the other inputs and outputs are distributed among seven 25-pin D-sub connectors. A 9-pin D-sub contains some remote
connectors for DIM, talkback and more. The pinning of these connectors is described in detail below. Apart from the headphone outputs,
all other audio inputs and outputs are electronically balanced. The input resistance is more than 10 kOhms; the source resistance is less than
50 Ohms. All inputs and outputs can handle levels of more than + 30 dBu.
TOOLMST
ST-IN
STEREO INPUTS 1-5
+
STEREO INPUT 4 RIGHT
-
Screen
+
STEREO INPUT 4 LEFT
-
Screen
+
- STEREO INPUT 3 RIGHT
Screen
+
STEREO INPUT 3 LEFT
-
Screen
+
- STEREO INPUT 2 RIGHT
Screen
+
STEREO INPUT 2 LEFT
-
Screen
+
STEREO INPUT 1 RIGHT
-
Screen
+
- STEREO INPUT 1 LEFT
Screen
nc
SubD-25 Connector
Female installed in device
Connector
ST-IN
This connector con-
tains the inputs of
the four stereo in-
put channels accord-
ing to the pinning di-
agram.
TOOLMST
MIX-INS/AUX/EXT
MIX INSERT SEND AND RETURN/AUX MASTER/EXT-IN
+
CTR SELECT EXTENSION IN RIGHT
-
Screen
+
CTR SELECT EXTENSION IN LEFT
-
Screen
+
- AUX MASTER 2 OUTPUT
Screen
+
AUX MASTER 1 OUTPUT
-
Screen
+
- MIX INSERT INPUT RIGHT
Screen
+
MIX INSERT INPUT LEFT
-
Screen
+
MIX INSERT OUTPUT RIGHT
-
Screen
+
- MIX INSERT OUTPUT LEFT
Screen
nc
SubD-25 Connector
Female installed in device
adt-audio
Connector
MIX-INS/AUX/EXT
This connector combines the
stereo master insert inputs and
outputs, the aux master outputs
1 and 2 and the stereo extension
input of the control room source
selector.
The extension inputs feed the
source select switch no. 9. De-
pending on the internal jumper
setting of the device this input
can also be used as an alternate
source for the ‚CTR' switch of the
playback source selector.
25