Power Supply Connection - adt-audio TOOLMIX16 User Manual

ToolMix/ToolMst User Manual
Power Supply Connections
All Tool devices use the same power supply connection with a balanced main audio supply voltage of +/- 25 volts DC. Each device has a
male and a female connector to daisy chain the power supply from unit to unit. The connectors are 5-pin xlr. The power supply connectors
include a 48 volts phantom power supply that is not used with the ToolMix/ToolMst units but included to keep the power supply compat-
ible with the other ToolKit and ToolMod units.
The picture shows the rear panels of a ToolMix8 and a ToolMst, powered by a ToolPwr-M with power cables installed. A 10 ft. cable connects
the output of the power supply unit with the ToolMst. A 1 ft cable
connects ToolMst with the ToolMix8.
IMPORTANT NOTES ABOUT THE POWER SUPPLY:
There are no life-threatening voltages inside the Tool devices. The
highest voltage is the 48 V phantom power. Special safety rules for
high voltage devices are not necessary.
THIS IS OF COURSE NOT THE CASE FOR THE POWER
SUPPLY UNITS!
VOLTAGES INSIDE THE POWER
SUPPLY ARE DANGEROUS!
READ AND FOLLOW THE
SAFETY INSTRUCTIONS ON
PAGES 6 - 10 CAREFULLY
YOUR LIFE IS IN DANGER!
adt-audio
15