Description - Shindaiwa 269Ts Owner's/Operator's Manual

Description

2
3
4
5
6 7
22
1. Front Hand Guard - uard between the
front handle and the saw chain for
protecting the hand from injuries and
aiding in control of the chain saw if the
hand slips off the handle. This guard is
used to activate the chain brake which is to
stop the saw chain rotation.
2. Rear Handle (for the Right Hand) -
Support handle located on the top of the
engine housing.
3. Choke Control Knob - Device for
enriching the fuel air mixture in the
carburetor to aid cold starting.
4. Silencer Cover - Cover the silencer not
to make operator touch to hot surface of
silencer.
5. Clutch Cover - Protective cover to the
guide bar, saw chain, clutch and sprocket
when the chain saw in use.
6. Chain Tension Adjuster - This is device
to adjust chain tension.
7. Chain Catcher - A projection designed to
reduce the risk of the operator's right hand
from being hit by a chain which has
broken or derailed from the guide bar
during cutting.
10
1
8
9
24
23
8. Guide Bar - The part that supports and
guide the saw chain.
9. Chain - Chain, serving as a cutting tool.
10. Front Handle (for the Left Hand) -
Support handle located at the left side of
the engine housing.
11. Fule Tank Cap - For closing the fuel tank.
Turn cap clockwise to tighten. Tighten it
rmly with hand.
12. Oil Tank Cap - For closing the oil tank.
Turn cap clockwise to tighten. Tighten it
rmly with hand.
13. Starter Handle - The grip of the starter,
for starting the engine.
14. Air Cleaner Cover - Covers air lter.
15. Cleaner Cover Knob - Device for
installing the air cleaner cover. Turn
cleaner cover knob clockwise to tighten.
Tighten it rmly with hand.
16. Primer Pump - When starting engine,
push primer pump 3 or 4 times.
17. Throttle Trigger - Device activated by the
operator's nger, for controlling the engine
speed.
20
10
11
12
13
18. Throttle Trigger Lockout - A safety
lever which must be depressed before the
throttle trigger can be activated in order
to prevents the accidental operation of the
throttle trigger.
19. Ignition Switch - Device for connecting
and disconnecting the ignition system and
thus allowing the engine to be started or
stopped.
20. Safety Decal - Part number X505-002441
21. Lifting Hook - If working off the ground
the operator must be trained in safe
climbing techniques and use of all
recommended safety equipment.
22. Operator's Manual - Included with unit.
Read before operation and keep for future
reference to learn proper, safe operating
techniques.
23. Tools - 13 × 19 mm T-wrench
(combination screwdriver spark plug
socket), small screwdriver.
24. Guide Bar Cover - Device for covering
the guide bar and saw chain during
transport and other times when the chain
saw is not in use.
19
18
17
16
21
15
14