Table of Contents
Advertisement
Establish USB Communication with DTV program
Connect the MD3004 to a PC's USB port with the supplied USB lead.
The DTV program immediately initiates the communication with the MD3004.
A message "Found, Getting configuration" is popping up briefly in the bottom left corner of the window.
If the communication cannot be established properly, a message "Found no hardware" is popping up
briefly in the bottom left corner of the window.
You will now notice that the layer containing the Configuration Menu buttons becomes active
Main Menu buttons
PLEASE BE CAREFULL NOT TO INTERRUPT OR DISCONNECT THE USB COMMUNICATION DURING
SWITCHOVER BECAUSE THIS CAN CAUSE YOUR PC TO CRASH (with possible loss of open file) AND THE
MD3004 MAY END UP IN AN UNKNOWN STATUS
Launching the management program
shows active status of power supply
pressing one of these buttons activates the configuration screen
in which all relevant input parameters of the HDMI signals and
the encoding and modulation parameters can be set
Configuration Menu buttons
www.abitana.com 7
Advertisement
Table of Contents
