Table of Contents
Advertisement
32-3008.fm Page 11 Thursday, April 6, 2000 4:03 PM
4. Set the desired channel volume level
slide control to the preset position.
5. Adjust
CUE LEVEL
tening level.
6. Start playback of the input source you
want to play next through your sound
system.
7. Set the input device to the desired sec-
tion of music, then stop or pause the
input device.
Switching to the Second Input
Source
1. Start playback of the second input
source.
2. Slide
CROSS FADER
you are ready to play the second
source's sound through your sound sys-
tem.
Slide
CROSS FADER
• To the left to fade in the channel
selected by
ASSIGN A
the channel selected by
• To the right to fade in the channel
selected by
ASSIGN B
the channel selected by
• To the center to equally mix the two.
Notes on Mixing
• If you set
CROSS FADER
channel selected by
must set
CUE ASSIGN
, to
to monitor
CH 1
CH 2
monitor
, and to
CH 3
. The same applies when you set
4
to
CROSS FADER
B
to a comfortable lis-
from
to
when
A
B
:
and fade out
.
ASSIGN B
and fade out
.
ASSIGN A
to
to play the
A
, then you
ASSIGN A
to
to monitor
CH 1
, to
to
CH 2
CH 3
to monitor
CH 4
CH
.
Operation
• To mix any two inputs selected by the
ASSIGN
switches, set each
switch to the desired channel. Then use
to mix the two.
CROSS FADER
• Do not slide
CROSS FADER
if you want to monitor one channel while
the other is playing. Otherwise, the
sound from the channel you monitor will
also be heard through your sound sys-
tem. Instead, slide
CROSS FADER
channel you are not monitoring. For
example, to monitor channel 1 (selected
by
) while channel 2 (selected
ASSIGN A
by
) is playing, slide
ASSIGN B
to
.
FADER
B
• Use
to listen to the input
CUE LEVEL
controlled by the
CUE ASSIGN
and what is playing on the currently
selected output device.
USING THE SPECIAL
CONTROLS
Using the Tone Controls
Your mixer has a set of tone controls for
each microphone and for channels 1–4. You
can tailor the high, middle, and low frequen-
cy sounds for each.
For normal sound, leave
set to
.
HIGH
0
Rotate
,
or
HIGH
MID
BASS
crease, or toward
–10
crease the high, middle, and low frequency
sounds.
Using Gain
Since the input levels of each sound source
are different, the
controls let you fine
GAIN
tune each selected input's volume. Rotate
the desired
control toward
GAIN
crease the volume and toward
it.
ASSIGN
to the center
to the
CROSS
switch
,
, and
BASS
MID
toward
to in-
+10
respectively to de-
to in-
MAX
MIN
to reduce
11
Hide quick links:
Advertisement
Table of Contents
