Table of Contents
Advertisement
RGB header
This header is for RGB LED strips
The RGB header supports 5050 RGB multi-color LED strips (12V/G/R/B), with a
maximum power rating of 3A (12V), and no longer than 3 m.
Before you install or remove any component, ensure that the ATX power supply is
switched off or the power cord is detached from the power supply. Failure to do so may
cause severe damage to the motherboard, peripherals, or components.
•
•
•
•
Digital audio connector (4-1 pin SPDIF_OUT)
Connect the S/PDIF Out module cable to this connector,
then install the module to a slot opening at the back of the
system chassis.
Front panel audio connector (10-1 pin AAFP)
This connector is for a chassis-mounted front panel audio I/O module that supports HD Audio
audio standard. Connect one end of the front panel audio I/O module cable to this connector.
•
•
PCI slots
The PCI slots support cards such as LAN card, SCSI card, USB card, and other
cards that comply with the PCI specifications
PCI Express 2.0 x1 slots
This motherboard has two PCI Express 2.0 x1 slots that support PCI Express x1
network cards, SCSI cards, and other cards that comply with the PCI Express
specifications.
PCI Express 3.0 / 2.0 x16 slot
This motherboard has a PCI Express 3.0 / 2.0 x16 slot that supports PCI Express
3.0 / 2.0 x16 graphic cards complying with the PCI Express specifications.
1-4
Actual lighting and color will vary with LED strip.
If your LED strip does not light up, check if the RGB LED extension cable and the
RGB LED strip is connected in the correct orientation, and the 12V connector is
aligned with the 12V header on the motherboard.
The LED strip will only light up when the system is operating.
The LED strip is purchased separately.
We recommend that you connect a high-definition front panel audio module to this
connector to avail of the motherboard's high-definition audio capability.
If you want to connect a high-definition front panel audio module to this connector,
set the Front Panel Type item in the BIOS setup to [HD Audio]. By default, this
connector is set to [HD Audio].
PIN 1
SPDIF_OUT
Chapter 1: Product introduction
Hide quick links:
Advertisement
Table of Contents
