Related Manuals for ABLE Ap25
Summary of Contents for ABLE Ap25
-
Page 1: User Guide
Experts in Small Printer Solutions Ap25 User Guide Able Systems Limited Denton Drive, Northwich, Cheshire CW9 7TU England Tel: +44 (0) 1606 48621 Fax: +44 (0) 1606 44903 Web: www.able-systems.com... -
Page 2: Table Of Contents
Note that copyright subsists in all Able Systems intellectual property, including controller firmware (embedded software) and circuit diagrams, pin connection lists and application data. No warranty in respect of patent rights of Able Systems Limited or of third parties is given. Unauthorised reproduction or amendment of controller firmware may result in prosecution. -
Page 3: Pin Connections
In the event that the power supply is not adequate to power the Ap25, on board Circuitry will hold the printer in reset and avoid any damage which may occur to the printer mechanism. -
Page 4: Operation And Programming
Note that the combination for 9600 Baud was used to select 110 Baud in the Ap24 family (110 Baud is not available in the Ap25). In order to implement the baud rate the printer must be reset. 4.3 EMC Compliance As a component, the Ap25 is outside the scope of the EMC Directive and the user must take responsibility for the compliance of the complete equipment or installation. - Page 5 The serial data input accepts a TTL or 5V CMOS positive true signal. The busy signal will be low when the printer is ready to accept data. The Ap25 is not suitable for direct connection to a PC RS232 Com. port. (Please refer to ASL for a converter board, or alternatively Able Systems produce an Ap25S which is the serial RS232 version of the Ap25 and is suitable for direct connection to a PC.)
- Page 6 French, German, “Scandinavian”, Danish/Norwegian, Swedish, Japanese and Spanish character variations (often to special order). The Ap25 contains all these variants, which are software selected for backwards compatibility. 8 bit data is selected when using the 8 bit IBM character set, otherwise the 8th data bit is ignored.
- Page 7 The command <ESC><126> stores the current character set and print mode (double height, etc) in the EEPROM and these will be the default setting the next time the printer is powered on or reset. If this code is not received the Ap25 reverts to previous default values on the next power up. <ESC><ESC>...
- Page 8 Earth Connection and EMC Screening Sleeve Able Systems Ap25 Series printers are fitted with an earthing wire attached to the metal chassis of the printer mechanism. The other end of the wire will be supplied attached to the panel clamp by an eyelet.
- Page 9 Paper Feed Enrouleur optionnel Alimentations SERIE et PARALLELE en niveaux TTL ou 5V CMOS Panel Cut Out 109mm 87mm 113.5mm 96mm Allow 6mm for panel clamp Dimensions & Connectors Ap25 User guide Page 8 of 8 Tél. : (0)1 34...